LENNOX
Lennox 14A45 PRESSURE SWITCH PRESSURE SWITCH
PRESSURE SWITCHThe 14A45 PRESSURE SWITCH has been changed to comply with the latest federal codes.Pressure switch 14A45 is a replacement for the AC pressure switch part number 9A4352 (RP14A45)...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountPressure Switch
Pressure Switch, power off reset switch, pressure control switch, low pressure cut out switch.
Lennox 10K56 Pressure Switch is designed for use with all Series 30 and 80 2-wire, oil-filled heating equipment to maintain properly regulated pressure. This switch has a temperature rise of 1% for every 9 degrees F when set at 90 psig and a temperature raise of 1% for every 12 degrees F when set at 125 psig (pounds per square inch gauge).
The Lennox 10K56 Pressure Switch is a 120 volt, single pole, pilot type pressure switch with an off delay. It is used to protect the blower motor manifold from excessive loading and is provided with a low pressure shut-off and dual high pressure set point contacts. - Voltage: 120V - Current rating: 20A - Time Between Reset (TBR): 9 sec
Using a quality PTO Pressure switch is very important. It may be the best investment you can make to protect your pump. However, picking the right one can be confusing. We have created this guide to help you select the right switch for your needs.
The Lennox 10K56 is a pressure switch that mounts to the blower motor and controls operation of the outdoor air damper.
The Lennox Pressure Switch is a pressure switch designed for use with a gas furnace. The Lennox 10K56 pressure switch helps provide stable heating in the home by regulating gas and feed to the furnace. The Lennox 10K56 pressure switch requires installation.
A replacement on/off pressure switch for the Lennox 10K56 two stage furnace. Replaces Lennox part number 1390001.