Ignition control board kit
B482675 Ignition control board kit
This is a new ignition control board kit, mounted on the circuit board, for use on Lennox gas/oil units. The part
Offered here is a Lennox ignition control board kit. Despite the slight damage to the top left corner of this Lennox 19M54 hea
Lennox replacement circuit board for the 19M54 Heater Ignition Control Module Kit. Small circuit board with microprocessor is used to control the ignition spark inside of a furnace.
This is a brand new LENNOX 19M54 HEATER IGNITION CONTROL MODULE KIT PCB CIRCUIT BOARD B482675. This is the part that ignites the pilot light and turns on the burners.
The Lennox 19M54 heater ignition control module kit, PCB circuit board (or pcb or printed circuit board) consists of four major parts: the printed circuit board; flame indicator lamp; overload relay contact block; and the main relay. These are the main parts of the ignition control module. When electrical current passes through all these parts properly, it will make sure that the ignition operates normally and let indoor heating equipment wok continuously. The ignition coil senses AC voltage from the wall outlet and releases a high frequency signal to the spark plug after being modulated by two different resistors. These HCF Ignition Modules
Lennox® B482675 19M54 Ignition Control Module Kit (PCB Circuit Board).