LENNOX 27L41 Corporation IGNITOR/FLAME SENSOR KIT

IGNITOR/FLAME SENSOR KIT

The IGNITOR/FLAME SENSOR KIT comes with a flame sensor and ignitor replacement. The flame sensor will shut off the gas if it detects no pilot flame. The ignitor is replaceable and will ignite the gas when the control knob is turned to the "ignite" position on the thermopile.

The IGNITOR/FLAME SENSOR KIT is designed to replace your faulty or damaged LENNOX 27L30 Ignitor/Flame Sensor Kit. The kit includes a flame sensor, mounting bracket and attachment screws.

Simple to install, built to last and backed by Lennox Limited Lifetime warranty, the Ignitor/Flame Sensor kit provides full protection from pilot ignition failure. The kit is designed for certain models in the Ite-Source series of gas valve packages and the HI-Lite series of gas valve packages.

LENNOX 27L41 Corporation Ignitor/Flame Sensor Kit

The Lennox 27L41 Ignitor/flame sensor kit is designed to replace your existing ignitor and flame sensor for enhanced performance. Easy installation with instructions.

The Lennox ignitor/flame sensor kit is designed to reduce the amount of time a high-pressure gas burner takes to start. In an ideal environment, this kit can shorten that time by up to 50%, allowing the heater to give off heat and reach the thermostat temperature faster. This kit contains a ignitor, flame sensor and wires for installation. For model numbers 27L4061-41 & 27L4062-41 USE KIT LEN27L4061

Remove the guesswork and enjoy the peace of mind that comes from knowing your furnace is safely controlled by Lennox controls. The 27L41 Ignitor/Flame Sensor Kit from Lennox allows you to replace your older, outdated flame sensor safely, ensuring a longer furnace life. This kit can only be installed by a certified HVAC technician.