A.O. Smith & A.O. Smith 100112148 PRESSURE SWITCH

PRESSURE SWITCH

This A.O. Smith & A.O. Smith 100112148 PRESSURE SWITCH is a genuine OEM replacement part that will help restore operation of your device. Made with OEM factory parts, ensure long term durability and performance of your device.

A.O. Smith & A.O. Smith 100112148 PRESSURE SWITCH 140 PSI to 200 PSI, 60 HZ, 1/2" NPT Bare Pressure Switch with Auxiliary Switch Head

A.O. Smith & A.O. Smith 100112148 DPA-100 PRESSURE SWITCH

A.O. SMITH & A.O.SMITH Model Number : 100112148 - Pressure Switch Part

Pressure Switch. A.O. Smith

Pressure switch for use with AO Smith Residential 50 gallons tankless water heater.

The AH4, AH6, AH8, AH12A, AH12B, AH12S, AH18K. AH36K. AH36E, AHP36E. APH36E, APH48G-1A Pressure Switch is designed to turn on the power to the solenoid valve when water pressure becomes adequate. The switch has a built-in 10 ft. cord with an inlet connection at one end and a normally closed solenoid valve connection at the other end

The A.O. Smith & A.O. Smith Pressure Switch is designed to fit select models of furnaces, water heaters, boilers and other equipment. This pressure switch includes the mounting hardware required for installation and features four color-coded terminals with corresponding wire leads to minimize installation time.

A.O. Smith pressure switch 100112148 is a common replacement part and can be used as a substitute for the part numbers listed below: 3SX9803; 3SX9803-00; 100112148;

This pressure switch has been used with the following products:

The A.O. Smith & A.O. Smith 100112148 pressure switch is designed to be used for water heaters with 5/8" compression fittings with a GPM of .570 - 2.3. The pressure switch will protect your water heater from damage due to leaking or a loss of pressure in the incoming cold water supply line, and turn off your water heater after 3 minutes of non-proportional rise in the incoming cold water pressure caused by a loss of hot water tank thermal mass, which could cause that rapid increase in incoming cold water pressure to damage your hot

A.O. Smith pressure switches are designed to monitor source water pressure. This switch is used in the following applications: Installation drawings for this switch are available under the Documents tab, above.