Honeywell 2273 7 in. well mount, rod and tube pneumatic 40-240 F temperature sensor

LP914A1052, Honeywell, Inc., Pneumatic Temperature Sensor, 40 to 240F

The Honeywell 2273 is a high quality Pneumatic Temperature Sensor that works with HVAC systems. These sensors are both economical and effective, and will not rust or tarnish. Connect this temperature sensor to heat sources in your HVAC system, such as microprocessor-controlled valves, dampers, valves, or actuators. This well mount, rod and tube pneumatic temperature sensor has a maximum range of 40 to 240 F.

Pneumatic Temperature Sensor 1052 is a Honeywell pneumatic sensor for air-Conditioning and Refrigeration systems. It is designed to mount in a pipe connection and measure the temperature of the refrigerant.

The Honeywell 2273 is a pneumatic sensor with a 7 in rod and tube well mount that is used to measure terminal or ambient air temperatures. Its -40 to 240F temperature range fits the requirements of any plant where temperature is an important factor in the production process. This simple-to-install sensor series can both collect and transmit data for on-line quality control systems.

Honeywell 2273 7 inch well mount, rod and tube pneumatic 40-240 F temperature sensor.

The 2273 is a well mount, rod and tube pneumatic temperature sensor designed specifically for mA metering in gas control systems. It has an operating range from 40 to 240 F (40 to 116C) with a sensing range of 5 to 180F (23 to 82C). The flat side of the case allows for easy installation in a 1in diameter tube or into a 2in split hub.

This well mount, rod and tube pneumatic temperature sensor is ideal for monitoring the temperature of liquids, gases or steam in a variety of process environments. This temperature sensor is encased in a micro-porous polypropylene housing that inhibits moisture absorption, which helps eliminate premature failure. It has a maximum operating pressure of 100 psi (0.7 bar) and can withstand up to 250 psi (1.7 bar) for 3 minutes. The temperature range is -40 to 120F (-40 to 49C).

The 2273 is a pneumatic adjustable temperature sensor that senses temperatures from 40 to 240 degrees F in 2 degree steps. It is normally closed and must be open to make a connection with the control valve inlet. The 2273 is used on systems in which the feedback of both high and low pressure signals are required during start-up, holding, and cooldown; providing precise monitoring of the final system pressure.