Honeywell 6381 150 lb-in Modutrol IV Motor, 120V, 90 degree stroke, 30 sec, 4-20mA Input 6381 .

120V VALVE/DAMPER ACTUATOR 150LB-IN

The MODUTROL IV products are designed for use in medium-to-high pressure vessels, such as tanks or pipes, and deliver a full range of linear and rotary motion. These miniature electric actuators offer the high precision, smooth operation and reliability you expect from Honeywell. This Series IV valve/damper actuator is suitable for many applications that require precise control of position. The S150 mechanism provides 150 lb-in of holding torque and it has an adjustable stroke of 0 to

The Honeywell 6381 single-acting valve/damper actuator is designed to fit on a 1 in NPT threaded spool valve stem. It has a maximum load of 150 lb-in (1087.6), 90 degree stroke, and uses a 4-20 mA input signal to open and close the air valve or pneumatic damper. An inverse magnetic interlock mounts directly to the case and ensures that moving one way cannot move the other way; it also prevents electrical

Designed as an actuator for a variety of valves and dampers, the 6381 AC Modutrol motor drives these energy-efficient products through standard single- and three-phase electrical outlets. The 6381 will rotate in excess of 200,000 cycles with no lubrication and no maintenance. It has a continuous rating of 150 lb-in (25 Nm) and 90 degrees of travel, with a rotational speed range from 30 sec to 0.5 sec per revolution. The 5347

The Honeywell 6381 Modutrol Motor Assembly is a 120 VAC, 50/60 Hz and has a 90 degree stroke. The 6381 has a maximum continuous @150 lb-in load; the actuator comes with a thermoplastic spool. The total stroke of this unit is 1.5 inches, and the rated voltage is 120 VAC; . This motor assembly uses 4-20 mA input signal, and it feature an AC output.

The Honeywell 6381 control is suitable for large industrial, commercial and agricultural applications where controlling motors or valves is required. It has a NEMA 1 enclosure with terminal strip. This heavy-duty actuator/splash proof switch may be used to control, two- to four-wire 120 VAC motors or modulating solenoids as well as serve as interlocks for crane gate/door operators.

The Modutrol motor is a small, heavy-duty actuator that can be used to control a wide variety of devices. It features a standard NEMA 2 enclosure with polycarbonate front cover and can be mounted directly to a panel or floor. Its special application potential includes fan louvers and duct dampers, door closures, blower components, valve shaft positioning, conveyor equipment and other machinery controls. A 1" square mounting hole is conveniently located in the base for installation adaptability.

Six-Phase, AC, DC or DC Stepper. The Modutrol IV series of AC, DC or DC stepper servo actuators provide a low cost alternative for controlling pneumatic valves in equipment such as air hoses, solenoids and damper/air valves when cost is the main consideration and system complexity.