MARS 19166 395V 166 Potential Relay 395V 166 Potential Relay

395V 166 Potential Relay

SUITABLE FOR MARS 19166 395V 166 Potential Relay The Mars 19166 395V 166 Potential Relay is a solidly built component that installs easily and will not rust or corrode. It is a product that will get the job done for a long time to come.

MARS electrical Products' 395V relay family provides high-reliability isolation and voltage sensing in industrial and commercial settings. Designed based on years of applied R&D, this product is ideal for demanding environments including dirty, new, renewable energy, and medical/life science applications which require an LCD display. Safety standard approvals including UL508; CE Mark; CSA C22.2; AS/NZS 3000:2009; IEC 60335-1:2008; EN 60950:

This TN contactor-type 396 volt, 50/60 Hz, two-pole switch is intended to be used with water-cooled power supplies with nonmultiplexed auxiliary relay coils used as optocouplers for direct control of water valve or other solid state devices. The VOLTAGE CONSTANT is 400 volts. The 400V COIL RATING gives a maximum coil current of 6.0 amp @ 600 Vac @ 130 deg C ambient temperature. Fusible link and

The Mars Service Select Series of potential relays offers a full range of current or voltage capability, a built-in surge protection circuit, and ten different mounting styles to accommodate the most common applications in electrical service. Designed for good vibration resistance and greater durability against thermal shock, these potential relays feature molded cases, NEMA 4X/IP65 protection ratings, and UL recognized components. For additional information about AutomationDirect's wide selection of industrial controls, call (877) AUTOMATION-1

The MARS 19166 is a 1-pole non-sparking, double-throw, vacuum type striker/coil unit designed for connection to all single or three phase buses. The commutation contacts will operate over the range from 0 through 165 volts and up to 400 amps sequentially with load currents of 100% rated current. This relay is interchangeable with suppliers part numbers 22.5 at one pole, 2RU914 at two poles and 22RP965 at three poles.

The MARS® Series is a modular relay system that will accept up to four field-installable potential relays. The small form factor of this switch, which makes it an ideal solution for control panels in enclosure panels or the junction boxes of panels. Unlike a standard rocker or toggle switch, the level of actuation voltage is precisely controlled.

The MARS 19166 is a relay designed to provide protection against overcurrent caused by short-circuit events. The relay features non-latching operation, allowing it to be used in series with other relays, devices or switches to drive lower voltage circuits, and is sealed against liquid pollution.