Fireye 63884 MEP100 "MICRO M PROGRAMMER "MICRO M PROGRAMMER

Programmer, Relight function.

A programmer is an electronic device that allows remote control of automatic incendiaries and other devices. This programmer is used to activate the relight mode when the primary system has failed, or not properly initiated.

Fireye's MEP-100 "Micro M Programmer is a microprocessor-based unit capable of monitoring and adjusting the output of one fire alarm control panel connected to it. It may be used to monitor and report status changes from a variety of devices within the system (e.g., combination smoke detectors, heat detectors, delayed-action devices, waterflow switches, manual pull stations) which can be individually selected for monitoring via local or remote conditions. The MEP-100 also has a built-in relight function that provides the ability to initiate or reset a system fault automatically after a user-determined time delay without

This product is a programmer that can be programmed to command over 100 different fire detectors to either sound an alarm for a predetermined amount of time or for a predetermined period of time. This product is also able to "re-light" a detector in the event that it decides not to sound the alarm.

This 2 Pole Universal Micro-Marine Prognostics programmer is for use with the most common Micro-Marine PID controllers in the Marine Power industry. The programmer will change all the operating parameters in one operation (except the micro-processor identification), including the setpoint time, setpoint mode, ratio of current and voltage (I/P), reset time and more. This feature makes it easy to upgrade the controller's software in just one step.

The Microm programmer is designed to be installed for a clean, uncluttered look, as it is the same width as standard fire alarm control units. A compact size with all the capabilities of its larger counterparts, the Microm programmer is designed to provide solutions for simple fire alarm system requirements. For use to control smoke detectors and alarms with sounders in small commercial and residential applications

The Fyrite 63884 MEP100 fire alarm "Micro M" programmer used to program the control panel and setting of Fireye's Micro M Series digital panel with a touchscreen display.

The Fireye Micro M programmer is designed to quickly and accurately make changes to multiple Fireye smoke detectors, smoke/CO combination detectors and detector panels. All units have two universal terminal blocks and a relay power connector. The standard connector for each detector is located on the small circuit board that is installed inside the detector or control panel. MEP100 Programmer will not work with DDX Series ALARMS - For these units use MEP200 Programmer