NewMar NMR-PC-10 Noise Filter, 10 Amp

Noise Filter, MFG# PC-10, w/10 amp capacity. Operates on 6-48VDC systems.

The Newmar NMR-PC-10 is a power conditioner with 10 amp capacity. The unit operates on 6-48 VDC battery systems and can be programmed with its built-in user interface to protect against a range of system issues such as voltage under- and over-voltage, low and high battery failure, along with shorted or reversed polarity connections. It has a filtering capacity of 300 VA (120VAC input).

The NewMar PC-10 noise filter is a DC power supply with 10 amp capacity. This noise filter is used to protect electronic equipment connected to it from voltage transients generated by switching power supplies like computers, monitors and printers.

The NMR-PC-10 is a noise filter with a 10 ampere capacity. It can handle a high magnitude of power pulses with absolute minimal loss. The unit will provide protection against any type of noise found in the typical garage, office or pleasure room. It has no voltage drop and will not overheat.

The NMR-PC10 10 Amp Power Noise Filter was designed to provide a noise canceling source and protect the equipment from any hazardous voltage transients that may be present. Not only does the Noise Filter offer protection, it also provides a clean, regulated source of power.

The NewMar NMR-PC-10 noise filter, 10 amp, is a line voltage or DC over current protector for water cooled hospital and dental compressors. This noise filter is also known as a spike buster. It protects against spikes on compressor power lines by diverting the fault to ground. The unit can dissipate 3.1 kilowatts to ground per minute and has built in surge protection.

The PC-10 Noise Filter was designed to be an economical source of noise suppression. This product will reduce electrical, mechanical, and environmental noise transmitted to audio and video systems. The PC-10 is excellent in reducing ground loop circuits and can provide greater than 100dB of attenuation, depending on the noise frequency substrate as well as associated impedance matching factors.

The NMR-PC-10 is a noise filter for DC power supply wiring. It reduces electrical noise from switching PSUs. This allows sensitive instruments to operate, often in cases where they would have been unable to run due to RFI interference. The design goes beyond protection of the equipment from noise; it also prevents annoying and disruptive interaction of the computer with the outside world.