240v Inducer Assembly
The Nordyne 903162 240v Inducer Assembly is a replacement Inducer Assembly. Used on the following Nordyne Air Handler Models: 70-903-011 and 70-903-022
This Nordyne 240v Inducer Assembly has a two terminal voltage setting switch. The inducer includes a motor, module and mounting hardware and is designed for use with the following gas furnace models: CTGMH30-1-50, CTGMH30-2-50, G75V26AEDA, G80V23EEDA. Dimensions: 17.375 " L x 14.625 " W x 8.5 " H
Nordyne 903162 240v Inducer Assembly Nordyne Motor consists of 3 rotating electrical coils in an assambly that runs on electricity. The three coils are electrically wired together with copper wire and a terminal block (typically a cast aluminum assembly) is used to make the connection to the outside world. The terminals are typically connected directly to your facility's 240 volt electrical service, therefore making them live or energized.
This Inducer Assembly is a direct replacement for the following: 903162 *** Replaces: 903162. This Inducer Assembly is designed to fit The Nordyne System Two 30kW radiant panel heaters. This Inducer Assembly has been tested to meet original specifications.
Nordyne 903162 Inducer Assembly
Nordyne Inducer Assembly | 903162 | FBG17| Fresh Breeze
The Inducer Assembly on the furnace is bolted onto the heat exchanger and pulls air from outside and into the furnace's heat exchanger. When the inducer is working properly, the furnace blower pull air past this assembly drawing hot air up through the heat exchanger venting from any registers in your home. These are original factory replacement parts