Nordyne 904561 Inlet Housing w/ Gaskets

Inlet Housing w/ Gaskets

The Nordyne 904561 Inlet Housing w/ Gaskets is an aftermarket replacement water heater part. Inlet housing has a brass inlet and outlet.

The Nordyne 904561 Inlet Housing w/ Gaskets is a pack of 2 that provide the perfect replacement for a worn-out part on your heating, ventilation, or air conditioning system. This product is just one piece of an entire line of supplies from Nordyne that offers exactly what you need to keep your equipment functioning at its highest level. The Nordyne 904561 Inlet Housing w/ Gaskets will be a dependable addition to your HVAC system for years to come, so order yours today. – See more at: http://www.diy.com/diy/

If your residential air conditioning unit came with an inlet housing, then it's likely that it will need to be replaced at some point. Because these products see a lot of wear-and-tear and environmental damage, they're more likely to break than any other part of the system. That's where we come in. We use only high-quality parts like this Nordyne 904561 inlet housing with gaskets when we manufacture new HVAC system components, which ensures that you'll be able to keep your home cool for many years without worrying about constantly replacing your equipment. If you have any questions

Do it yourself home repair gets a lot easier with the 904561 Inlet Housing. This product works to keep your air conditioner/heater operating at peak performance. It fits compatible brands including GE, Hotpoint, and Kenmore. This home improvement essential comes in a variety of finishes: white, almond, and polished brass.

The Nordyne 904561 is a direct replacement inlet housing with gaskets. It measures 3-13/16 inches in diameter.

The Nordyne 904561 Inlet Housing is a low pressure gas connection that comes standard on most outdoor appliances. Condensation occurs inside the inlet housing because there is not a constant supply of sub-cooled refrigerant in the system. This causes condensation to form when the heat source (the burners) turns off resulting in water droplets forming inside the inlet housing and ultimately dripping onto the outdoor appliance control panel. This is a normal function and will result in an accumulation of water over time. It is recommended that the inlet housing be drained by opening or cutting off the vent cap while the unit is

Standard replacement inlet housing for NAC90 furnace manufactured from 2000-2002.