OTC OTC-5055 MAMUAL SLACK ADJ PULLER

Manual Slack Adjuster Puller for Trucks and Trailers

Designed to adjust slack in torsion-type spring binders when it is necessary to remove or install a tandem axles, or in any other situation where the spring binders must be slackened while being raised or lowered

For use with all types of torsion-type spring binders

You simply slip it on over the adjusting screw, apply pressure downward and rotate until it releases

The OTC OTC-5055 MAMUAL SLACK ADJ PULLER adjusts the slack in trailer wheel chains or cables

You'll save your back, and you will no longer be at risk for injury if you use this tool

All OTC-5055s have a 1/2” (12 mm) square drive and are qty 4 per case

This manual slack adjuster puller works with all standard size tie downs

OTC-5055 MANUAL SLACK ADJ

The Slack Adjusting Tool takes the hard work out of removing the slack adjusters

OTC OTC-5055 MAMUAL SLACK ADJ PULLER

The manual slack adjuster puller (AKA: Slack Adjuster Puller, Slacker Remover, etc

The OTC-5055 Manual Slack Adjuster Puller is designed to be used primarily on rear axle slack adjusters on trailers, but can also be used on differentials and brake adjustment assemblies

This compact tool makes adjusting your slack adjuster fast and easy

Our OTC MAMUAL SLACK ADJ PULLERSs are manufactured with the highest quality materials and can be found in various industries

The tool is easy to use and requires no special skills or training

This OTC MAMUAL SLACK ADJ PULLER is a part in OTC's Manual Slack Adjusters product line

It helps to eliminate fuel consumption, excessive wear on tires and rolling resistance caused by excessive slack

It works to pull adjusters back into the housing by applying a pulling force via the threaded side handle and an eccentric cam that forces the slack adjuster to rotate

) is a manual operated device used to remove the slack adjuster from a trailer or truck axle

PULLER FOR TRUCKS AND TRAILERSThe OTC-5055 is a manual slack adjuster puller with an ergonomically designed handle

For use on single and tandem axle trucks, trailers, dollies and machinery

With a manual puller, there is no need to have air pressure applied during adjustment

The hardened jaws on the puller grip the adjuster to provide the largest amount of holding power while still allowing the user to rotate the adjuster

The manual puller allows the slack on the main line to be adjusted to the proper tension

It features a built-in plier wrench that saves time and money

Manual Slack Adjuster Puller for Trucks and Trailers is a device used to manually adjust the slack on an air brake main line

This tool is constructed of steel and has a zinc-plated finish