OTC OTC-7471A Engine Barring Tool for Cummins

Cummins Engine Barring Tool

The OTC-7471A is a Cummins engine barring tool

Cleans, depassivates, and retards rust in the cylinder bores

This part is made of high strength steel and can be used on all models of Cummins diesel engines

These engines have an interference fit between the crankshaft and the crankshaft belt pulley, which means that if you do not use this preventive measure, you will damage your engine

It is used to hold the flywheel or crankshaft when cranking the engine manually

OTC Engine Barring Tool for Cummins

Coupled with a suitable lever, it can be used for almost any purpose where a pry bar or lever is needed

The Cummins Engine Barring Tool is designed to fit in the 3/4" x 9/16" hex slot on most Cummins engines

OTC OTC-7471A Engine Barring Tool for Cummins

This tool allows for removal of the belt pulley without damaging your engine

Use this bar tool to prevent engine from turning on a Cummins engine that is installed on a truck or other equipment

Cummins Engine Barring Tool for Cummins

The tool is attached to a 3/4" bolt and nut combination and tightened down against the belt by hand

Compatible with all diesel engines

OTC-7471A Engine Barring Tool for Cummins

OTC-7471A Engine Barring Tool for Cummins Engines

Cleans intake valves to help restore power loss due to carbon build up

It is used to secure the crankshaft in order to remove the flywheel

Engine Barring Tool

Cummins Engine Barring Tool #7471A The Cummins 7471A is a tool that is used to remove the crankshaft pulley on a 6CT or 6BT diesel engine when replacing the water pump

Removes carbon build up in fuel system, injectors and pumps