Honeywell 290818 PREMIER WHITE 24V/750 MILLIVOLT WI-
PREMIER WHITE 24V/750 MILLIVOLT WI-Honeywell has been a trusted name for more than 100 years. Our PREMIER White 24V/750 Millivolt Wi-Fi Thermostat gives you the freedom to manage your home's...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountTemp Adj Zone Sensor W/ComJack
The Peco Water & Gas Wiring Temp Adj Zone Sensor W/ComJack is a high-quality replacement for your old, bad parts. It is reliable and good in quality as the original one. It helps you to install or fix your ?''' system easily with no need to buy other unnecessary parts.-This sensor comes with convenient routing holes for easy installation of wiring.-This sensor features a 1 inch diameter that fits seamless into an existing setup - This sensor comes complete with wiring harness and
Peco Controls' Temp Adj Zone Sensor w/COM Jack is a zone sensor for use with network temperature controllers. The product accepts the standard two-wire temperature probes that are offered by Peco Controls and other manufacturers.
The ComJack is used to connect the controller to other devices that use a 4-Wire Coded Modular Jack. Plug either a Modular Adj Zone sensor or a Meter Bridge into this jack to connect them to the Controller.
The Peco Controls SP155-027 is a zone sensor with standard O/P of 28Vdc, 5A rated and a ComJack™.
This Temp Adjustment Zone Sensor allows Interlogix/GE/Nortek Security & Control Systems (S&C) to provide remote thermostat control of zone temperature. Features: Monitored 4-12VDC input for zone temperature compensation; Range 40 F to 120F (4 C to 50 C); Zones cannot be adjusted w/out secondary relay; Connection Instructions: three wires, red (120VAC), white (common) and black (-); Underside of the
The ComJack features an internal jack, connector and 14.25" of wire that connects to one Zone and allows for multiple sensor connections to other zones Temporarily controls output load up or down to adjust temperature, or change control settings while preventing zone burnout during testing Drill hole diameter is .313" .390" (10mm - 15mm) Two position switch (Up / Down) For use with a single supply 3-wire cable with a max run of 50
This Zone Sensor is for Peco Oil-Filled Zone Valves. The sensor is 6" in length with a ¼"-28 NPT male threaded end. This sensor is for Peco oil-filled zone valves that use the D-Series line transmitter and ComJack®. Use of padlock to secure cable at valve end, key available from Hill Brothers upon request.