PHASE CONTROL for Star - Part# SP-115339

PHASE CONTROL for Star - Part# SP-115339

PHASE CONTROL for Star - Part# SP-115339

Phase Control for Star is a special driver board for the Phaserunner motor controller (as found in the LSN-series of motor drivers). It allows you to run motors in 3 different phases with 3 different outputs.

Phase control for Star garage door openers is intended for installation in an existing opener to allow the operator to rotate the motor in a single direction. While running in one direction phase control synchronization is instantaneous with the door movement, while running in the opposite direction it can be adjusted to eliminate any lag.

Part number 115339 controls 100% of the current flowing through the two heating coils in the output stage of a Star Delta starter. This allows operation with a 3-phase power source in which the power phase rotation is unknown. Features Phase Indicator Lamp, 158-30 Amp Fused Connection, 120/240 VAC Catalog Voltage 2220 Magnetic Base Indicating Light: 20/30 Amps Current Display: Green = 20 Amps Yellow = 30 Amps Red = 60 Amps Three Hour Timer: ON for 3 Hours OFF for 18 Hours

The phase control assembly that is used in many of the Star models.

Phase control is an easy to install product that can save you a lot of energy and money. The installation is quick and simple and it takes just minutes to mount on your air handler. Phased control allows you to run two or more air conditioners from one thermostat by installing the control on an air handler which is supplying 2 or more indoor units.

Phase Control is a compact electronic module that lets you switch between heating a small space or large area with the Star Series heaters. With Phase Control, you can adjust the output of your heater up to 15oF more than digital models.