Q314A-6094 PILOT ASSEMBLY HONEYWELL
Save your money and buy this high quality "HONEYWELL 2402 Q345A Q345A2 Upgraded Universal Replacement Furnace Pilot Burner Ignitor Igniter Q314A-6094 PILOT ASSEMBLY HONEYWELL [Q345A-6094]".
The Q345A is used to replace a damaged or broken Q345A. It is a direct replacement for part numbers Q345A-6094, Q314A-6094. The standard replacement also includes a Used on Models: RKE4111B1000, RKE4111B1200, RKE5111B1000, RKE5111B1200
The 3-Pack of PILOT ASSEMBLIES by Honeywell is designed for use with a variety of furnaces, gas burners, and other appliances that require a pilot flame to ignite the main burner. Installation is simple and takes only minutes. It's compatible with ignitions used by Carrier, Bradford White, Bryant, Payne, Ruud, Tempstar and more.
This part is a genuine Honeywell Furnace Pilot Assembly. This pilot assembly is a very common failure on numerous models of heaters including the York Heat Mode IMH3-120, The Bryant HeatKing, BDP3Q-8---8B; Eden Pky-415, and many others. Works with any heat mode blower motor: tangential, centrifugal, or counterflow.
Allow for easy on/off ignition with this Honeywell replacement pilot assembly, 2402. It has a 1/4 inch wire size that causes the burner to turn on and off automatically without the need for manual operation. The same applies for exhausting the gas, allowing for automatic deactivation, too. Crafted from durable steel, this pilot assembly is built to last and withstand everyday use. This pilot assembly also comes with a protective cover that prevents it from getting contaminated.
The Honeywell 2402 Q345A Q345A2 Upgraded Universal Replacement Furnace Pilot Burner Ignitor Igniter is an everyday, all-purpose type of direct ignition device. Common applications include pilot operation and low temperature burner operation on gas stoves, heater, furnaces heating equipment, etc
The Honeywell wall switch control is a Honeywell furnace/boiler control for gas furnaces with solid state triac operation. The pilot signal for your gas furnace is an electrical current that heats up the pilot light, which in turn heats up a high temperature tungsten filament until it glows and ignites the furnace's burners. It is important to have the right pilot signal because if the pilot is out, your burner will not ignite and heat your home properly.