HONEYWELL Q7300D1038 Q7300D1038 SWITCHING SUBBASE FOR 2 COMPRESSOR

SWITCHING SUBBASE FOR 2 COMPRESSOR

The Q7300D1038 is a switching Subbase for 2 compressor loop systems. This Switching Subbase is compatible with Q5900D1038 and the Q6100M4. It has a 12-gauge steel case

The 2-in. switching subbase allows you to run two 400-volt communicating pressure switches, and includes an integrated 4 way connector for use with QAS compressors. It is designed for use with 7.0 Qt. single stage and 15.0 Qt. dual stage intercooled compressors.

The Honeywell Q7300D1038 Switching Subbase accommodates two 1/2 HP, single-stage, 208/220 volt gas compressors. It features a built-in time delay switch (6 minute timing range) for compressor start up. The subbase is compatible with Honeywell Q8200 Series (Q8250 and Q8251), Q9100A and Q9160 Series (Q9170 and Q9271) modulating condensing units requiring a switching head.

Replacement switching base for  Q7300D1038 . This switching base is used to run two 5HP compressors.

The Q7300D1038 is used in refrigeration, air conditioning, and other applications where a single compressor is used for both heating and cooling. This switching base uses a short-term energy wheel to switch energy between two compressors during the operating cycle. The mounting hardware includes a factory installed stud with nuts and a stud keeper spring.

The Q7300 Switching Base is a 2-compressor switching base designed for use with any of the following; air conditioners with a cooling capacity above 2.5 tons, one-stage heat pumps with a cooling capacity above 2.5 tons, or two stage air conditioners. This switching base has a single motorized dampening and bypass valve. It also features easy-to-use electronic controls, and fixed outside air and refrigerant piping connections.

A switching base with two input lines for refrigeration and air-conditioning systems. The unit is equipped with a starting contactor, overload relay, and an automatic reset function.