Johnson Controls 3517 Size 1/8 in. Air Pressure Reducing Valve, flow capacity 1/0.5

1/8" AIR PRESSURE REDUCING VALVE

The Johnson Controls 3517 Size 1/8 in. AIR PRESSURE REDUCING VALVE is designed for use with high pressure manifold systems. This valve reduces maximum operating pressure to maximum of 50 psi. It is made of brass, reducing the chance for dirt or mineral deposits to form.

This is the exact size 1/8" air pressure reducing valve that matches the specs of the original. If you are replacing, make sure you get the right size otherwise swap this one out with another piece of junk!

The Johnson Control 3517 Size 1/8 in. Air Pressure Reducing Valve (flow capacity 1/0.5 SCFM at 100 PSIG) features a flow-enhanced diaphragm that is designed for accurate, repeatable control. The valve also includes a firestop clamp ring stop for added safety. The rugged aluminum housing has a nickel plated finish for corrosion protection, and the regulator is interchangeable with other Johnson Control regulators for easy conversion to other gas pressures. The compact design helps you save space when pressurizing or dispensing various gases.

This large format 1/8" Pressure Reducing Valve features a bright nickel finish. The valve is designed to provide an economical method for controlling compressed air pressure, pressure changes or varying vacuum requirements.

The Johnson Controls Size 1/8 in. Air Pressure Reducing Valve, for use with Parker Conrad or ConradJ-Series J/E & PCJ-Series Pneumatic Tire Valves, features a modular design that allows the valve to be used on flat, metered-dose or turbine-mixing hoods. When used with the Parker VXS controller, the valve will enable metered dose through airflow rate control.

The Size 1/8 in. pressure reducing valve, flow capacity 1/0.5, is used to reduce low pressure or high pressure gaseous systems to a required lower pressure level. The size 1/8 in. is designed for most commercial applications. The valve incorporates several benefits including its ability to activate with higher initial inlet pressures and it also operates with larger temperature fluctuations than the smaller capacities.

This 0.5 psi air pressure reducing valve reduces the air pressure from a standard 25 psi compressor to a pressure range of .5 psi, which is ideal for spraying light foam from decorative paints and polyurethane applications. It is suitable for use with air-fed spray guns.

Valve, pneumatic, size 1/8 in., made of brass, nut & wing type with pressure reducing capability to -500 psi (-344.5 kPa), maximum working pressure to 300 psi (207.8 kPa), NPT connection size 1/8 in., A-thread flow capacity 0.5 gpm (1.9 Lpm), flow coefficient 0.2, current rating 30 amps -3500/6000 A

With a durable, construction this Johnson Controls pressure reducing valve provides a wide range of matching properties. It is suitable for repair and replacement of damaged valves.

Reduce pressure in air system up to 40 psi. Flow capacity 1/0.5. Stainless steel construction.

Fits between inflator hose and valve stem on the tire.

The 3517 Series has a brass body and bonnet construction, and is designed for use on hot and cold water systems. It reduces water system pressure by reducing the operating pressure to less than 50 psi (3.4 bar) maximum. These reducers are packaged in a variety of configurations to meet the requirements of single or multiple taps.