RHEEM 45-25323-02 Flame Sensor Wire - 42 in. (1/4 in. Quick Connect

Flame Sensor Wire

Make sure you home is protected from hazardous fires and be one step ahead with the DFS16110-1 Flame Sensor Wire. This 42-in wire can be used to surround a fireplace, woodstove, or other open flame devices which could lead to an unwanted fire. This flame sensor wire can easily be secured to a wall or ceiling in any room of your home in minutes. Don't enjoy wasting time on replacements, since the flame sensor wire works for years and are simple to replace when needed. If you want peace of mind while inside and outside your home, the product you need is right here.

RHEEM Flame Sensor Wire 42 in. [1/4 in. Quick Connect] to power a combustion sensor.

Light up the BBQ grill with the Rheem 42 in. Flame Sensor Wire (1/4 in. Quick Connect). This easy to use wire resistive flame rod enables you to monitor the temperature level of your new Rheem gas grill and automatically shut off its burner when complete so your food won't burn.

The Rheem Flame Sensor Wire is used to replace a faulty flame sensor wire or for additional flame sensors. The 42in. flame sensor wire from Rheem comes with a 1/4in. quick connect making it easy to install on compatible heating units. Just connect the flame sensor wire to an appropriate thermostat and place the other end near a heat source, such as a combustion appliance, heater, water heater, fireplace, or pilot light.

The flame sensors protect your RHEEM installation from overheating and damage. This Flame Sensor Wire is the correct replacement wire for the cable assembly. Each wire has a length of 42" and a 1/4" Male Quick Connect Connector on both ends of the wire.

The flame sensor wire (thermocouple) is used with an electrode to sense pilot flame or hot surface in the combustion chamber.

This wire can be used to transmit signal from a flame sensor to a control module, thermostat or other interface device. Flame sensors detect the presence of flame by measuring the temperature of the objects that surround them. The use of these devices is essential to safety and efficiency of most water-heating systems. This flame sensor wire is great for all Rheem furnace models, as well as Bradford White and Lochinvar boilers and tanks.