RHEEM 70-104157-83 -Ruud Induced Draft Blower w/Gasket

Induced Draft Blower w/Gasket

Induced Draft Blower w/Gasket. Compatible With Model Number: 70-104157-83

This Rheem induced draft Blower w/Gasket is designed to be used with XRT106 and WLTU57 series furnaces. The WLTU57CEC blower includes a gasket that ensures proper installation in the furnace. The RHEEM A88061530 Induced Draft Blower w/Gasket is built by skilled factory workers to ensure the quality of your product.

Induced draft blower with gasket.

The Induced Draft Blower (IDB) is designed to work with any Ruud direct vent unit. The IDB features a fixed elbow to allow for piping access, and a gasket that helps create a tight seal. All Ruud gas furnaces should be installed by a qualified HVAC contractor.\r

The Induced Draft Blower for Ruud 70-104157-83 is commonly used on junkers and is included as part of the 70993690 CH60F164CC "Replace All Parts" combo.

Designed to increase the efficiency of forced draft furnaces, this induced draft blower is perfect for homes with standard or power venting systems. Featuring an integrated gasket that ensures tight installation, this blower draws in air from outside the home and circulates it to the furnace's combustion unit. This efficient appliance reduces home energy consumption by increasing the amount of heat created.

The Ruud Induced draft blower is a part of the Ruud heating inducer assembly. The induced draft blower consists of a motor with a fan and impeller attached to the shaft which is carried by ball bearings. The shaft extends from the motor through the blower housing and exits on one end. A spacer ring is located between the bearing retainer and the blower housing to hold the bearings in position. The bearings are designed to resist pressure from either side, since it has been found under field operating conditions that both atmospheric pressure and suction will act on these bearings. The ball bearings will become damaged