Flame Rod Kit
The Flame Rod Kit is designed to fit Ruud gas appliances using the RHEEM/Ruud 24-230V/MPT
The Flame Rod Kit comes with 2 Flame Rods and the brackets that hold them. Each Flame Rod is designed specifically for your gas furnace to ignite and burn gas properly for optimal efficiency.
Flame rod kits are used with gas water heaters to prevent freezing and ensure continuous service. Flame rod kits are constructed of stainless steel for corrosion resistance and long life, and supplied in box quantity.
Aflame rod kit for R-Series tankless water heaters, model numbers 62-24044-71 & 62-24044-85. Flame rod kit must be replaced if odor or gas escapes during use. Replace flame rod kit as soon as possible after the first sign of gas coming from the burner assembly or gas escaping from the water heater.
The Flame Rod kit contains three 9 inch and four 5 inch Flame Rods. The kit is designed to work with Rheem, Ruud, and Peerless model furnaces when extra capacity is required for use in very large rooms with greater air volume requirements or in high density areas such as hotels, hospitals or schools.
The flame rod kit includes a rolled tip low NOx burner assembly, installing hardware, and explosion-resistant access cover.
The Ruud Flame Rod Kit is for use with gas furnaces and consists of three flame rod assemblies for front to back and two flame block assemblies. Flame blocking rods prevent burn-through and protect the heat exchanger from damage by the burner flame. These rods also help control the variability of the gas burner, reduce tip-off potential during combustion, and prevent re-ignition of flame in unburned gases occurring in bottom of furnace heat exchanger.