Rheem AS-61706-09 9Pin To 9Terminal Harness 9Pin To 9Terminal Harness

9Pin To 9Terminal Harness

9Pin To 9Terminal Harness is used to connect a 9 pin to a 9 terminal harness.

9Pin To 9Terminal harness assembly for Rheem gas or gas/electric water heaters. This harness provides a plug-in connection for the thermocouple and heater elements.

The Rheem 9Pin to 9Terminal Harness is a 1/0 gauge wire harness that helps to eliminate additional wires and get longer wire lengths.

This 9Pin to 9 Terminal harness is exactly what it sounds like, the black plastic wire harness you plug your TSTAT wires into and then attach those wires to. While it's not the most exciting component in your furnace, the 9 Pin To 9 Terminal Harness is a vital piece of your heating system. Keep one on hand so that you can replace your household heating system if it ever breaks or starts to malfunction.

This is a New 9Pin to 9 Terminal Harness! It can use with the following Rheem, Ruud, and Nordyne Furnaces:

The AS-61706-09 9Pin to 9Terminal Harness is used in applications where the Rheem Residential heat pump's zones do NOT include an electric point for a communicating thermostat. This is typically replaced by a non-communicating compatibility kit, but this harness will allow for a 9-terminal thermostat communication with Rheem residential heat pumps.

This Rheem 9Pin to 9 Terminal harness is used in Rheem, Ruud, and some indoor furnaces using an 9pin control board. There are two wires running from the control panel that plug into these terminals.