Honeywell 2717 , Inc. Pneumatic Three-Port Selector Relay, Panel, In-Line or Wall Mount.

HI PRESS.SELECTR RELAY 0-18PSI

This 2717P SEL relay is a pneumatic pressure selector switch designed for use in panel, wall and in-line mounting configurations. It utilizes an SPDT coil operating on pressures of 0-18 PSI (0.96-143 kPa) and is designed for switching smooth bore tubing with tubing connections of ½ inch to 2 inches (12.7mm to 50.8mm).

The Honeywell Selector Relay 2717 is a compact motor starter for pneumatic conveyors or other applications. This selector relay has a maximum operating pressure of 200 psi and a maximum inlet pressure of 18 psi. The relay can either be mounted to the wall or used as an in-line unit.

This relay is a high pressure, three-port, pneumatic selector relay that conforms to performance requirements of MIL-R-3484. It is an in-line or wall-mount mounting, prewired 155° C, 30 psi rated relay that is used to switch high pressure air from one device to another.

The Honeywell Pneumatic 3-Port Selector Relay allows up to three pneumatic devices to be connected in series, while only requiring the mounting of a single device. Each port is independent to allow any combination of positions between the ports, and an on-off switch is provided on each port for each device. The relay can be mounted in an open panel or in a wall box.

This Pneumatic Pressure Selector Relay is a normally closed automatic pressure controller. This selector valve is operated by depressing one of the four push buttons, each button actuates a normally closed relay contact on the front face of the pressure selector. The top button closes a pilot contact or pilot relay to supply power to the solenoid valve, and when released, opens that part of the circuit. The pilot relay coil is always energized when main power is on, and provides an open circuit to the solenoid coil until it contacts its mating pair of normally closed relay contacts and closes them.

The Honeywell Selector Relay is used to sequentially energize a single device or circuit from a variety of other devices or circuits. This relay replaces many contactor modules and manual switching systems that cost more, require maintenance and use up valuable space.

This Honeywell In-Line or Wallmount 3 Port Application Selector is a three port industrial application selector. This relay can be wired in line on pressure and One actuation outlet. It is typically used in applications where there are multiple applications, but only one is required at a time. For example, (Valve 1 has to close before Valve 2 opens and so on). The other two outlets are common runs. Panel mount versions have Pneumatic connectors for panel mounting.