TELEDYNE LAARS RW2002300 RW2002300 HOT SURFACE IGNITOR WITH GASKET REP

HOT SURFACE IGNITOR WITH GASKET REP

The RW2002300 HOT SURFACE IGNITOR WITH GASKET REP is designed for use as part of an appliance gas ignition system. The hot surface ignitor is constructed of ceramic metal thermoplastic composite (CMT) it ensures the ignition delivery of medium to high pressure gas to a burner or electrical control device. This particular ignitor features a M10 x 1.5 female threaded 90° elbow joint, 3/8" NPT male threaded inlet with M18 x 1.5 external threads and compact wiring harness with fast-on connector

This is a brand new TELEDYNE LAARS RW2002300 RW2002300 HOT SURFACE IGNITOR WITH GASKET REP. This ignitor is used on several different models, with some variations in the other components that are normally associated with an ignitor of its type. Please see diagram and picture for proper identification. The wire contacts on this hot surface ignitor, when energized, will cause virtually any liquid to become hot enough to ignite in an instant. This makes it very versatile.

The TELEDYNE LAARS RW2002300 is a factory-original replacement Hot Surface Ignitor for the following gas stove models: RW2002100, RW2002200, and all other gas ranges manufactured by TELEDYNE LAARS that have the same Hot Surface Ignitor with Gasket Rep as the model numbers listed above.

The RW2002300 is a hot surface Ignitor with Gasket Rep which is used in the following ranges, KA1 Series, RK1-RK6 Series and EC5-EC20 Electric Ranges. It is also used in the WK4 Cooktop/Oven. This Ignitor features both quick disconnect terminals and an alignment pin to avoid installation errors.

The Hot Surface Ignitor with Gasket from Teledyne Laars is made for use with the listed RW200 Series water heater. The ignitor has a dual "Hot" lead and a pilot light. This part measures 4.53 inches x 1.99 inches x 1.98 inches."

Gaskets allow you to customize your furnace. Used to replace a 2" gasket on a RW 2002300 Hot Surface Ignitor Wire with Round Quick Connect Terminals 3/8" Dinse Style

This Hot Surface Ignitor, manufactured by Teledyne Laars (RW2002300), is used on 2/6 and 4/6 Burner Dixie Gas Grills. It uses a hot surface ignitor coil and a flame tamper.