YORK S1-02921182042 GAS ORIFICE DRILL SIZE .042 GAS ORIFICE DRILL SIZE .042

GAS ORIFICE DRILL SIZE .042

The GAS ORIFICE DRILL SIZE .042 is designed with a rugged steel structure and rugged plastic body for rugged use in the highest demanding applications.

GAS ORIFICE DRILL SIZE .042 (0.225mm)

The YS1-02921182042 Gas Orifice Drill Size .042 is designed to assist you in drilling gas orifices to exacting tolerances. Sizes .040 thru .051 are used for non-CD.

Sometimes the right tool for the job is a drill bit! Need to drill a smaller hole than your standard bit? York has you covered. This .042" gas orifice drill bit will do the trick.

A 0.042" diameter gas orifice drill is ideal for use in pre-heating small natural gas convection heaters built after 1958 and gas central heating systems. This orifice drill is used to create a small opening in the brass adjustable air vent holes to allow enough air into the system as the system heats up. This allows the system pressure to build as fast as possible without causing excess pressure in the system.

York's micro-fine 0.042" gas orifice drill bits are designed to provide the precise amount of gas needed for each application, for each location drilled.

These orifice drills are used for making gas ports or gas holes in metal, plastics, castings, laminates, composites, etc.

Whether you’re installing your own water heater or dealing with a broken one, this drill bit is designed for use with high pressure gas lines. You can easily size the gas orifice to ensure that the gas flow is appropriate for the appliance's needs.

Attach A chuck collet or collets on to the shank of the tool holder and you are ready to drill.

This drill is a combination drill and reamer. This bit provides a pilot hole for a dowel or pin. Bits of this style are used on a regular drill press, not a lathe. The chuck would not allow for the correct geometry.

Helps to ensure the valve seats are clean