Honeywell 35342 - REMOTE RESET MODULE TO RESET 7800 SERIES RELAY MOD.

REMOTE RESET MODULE TO RESET 7800 S

The Honeywell 35342 Remote Reset Module to Reset 7800 Series Relay Module includes the reset capability of the RTU terminal equipment, which is required for two-wire smoke detectors/alarms that cannot be reset outside of the panel. The module allows a wireless two-way communication between the Wireless Keypad and separate Wireless Keypad Transmitter for wireless keypads and remote reset. Enhanced DIP switches are available for select Honeywell Security Systems panels to allow for stand-alone operation (wire

Use this Remote Reset Module to reset your Honeywell 7800 Series (N-HT-H705W, N-HT7806W, N-ST-H705W and N-ST7806W) system if you're away from the security panel and need to disarm the alarm. Features an integrated resettable normally open switch with a range of up to 100 feet when used with an appropriate extension cable. Comes with mounting screws, screwdriver and a wiring diagram.

Replenish the remote reset module for the 7800 Series relay contactors (7801, 7802, and 7003). The remote reset module is available as a spare to anyone purchasing or replacing a 7800 Series relay contactor. The remote reset module, like the contactor itself, can only be purchased as a replacement part for a previously installed 7800 Series relay contactor.

The Honeywell 35342 Remote Reset Module will reset all Honeywell 7800 series programmable thermostats remotely. The reset module will beep once to indicate power and goes into a search mode for the thermostat being controlled. Once the module locates the thermostat, it beeps twice, to indicate that the reset module is connected to the thermostat. On our non-battery powered units, the unit ignores this command and sends out another SEND command sequence with a

The Remote Reset Module allows for easy resetting of the Honeywell 7800 series Relay Modules. This remote reset module can be used with all Honeywell 7800 series away and door/window contact devices that contain a relay to provide audible alarm verification.

This easy to use Remote Reset Module replaces the need for a hardwired reset circuit. The remote module is conveniently integrated with a small status display and comes with mounting hardware, wire, and connectors. Pre-programmed for maximum performance, simply connect the module to your Honeywell 7800 Series relay board via the terminal block. Once connected, press the power button on the module and you are ready to use your remote reset unit!

The 7800 Series Remote Synchronization Module is designed to provide local reset capability for Honeywell's 8600 Series wireless load controller. When connected to an IP gateway or other remote signaling device, the module can be used to remotely reset a load being controlled by a 7800 Series wireless load controller.