SEA-DOG LINE354-4451981 ATO/ATC INLINE FUSE HOLDER

ATO/ATC INLINE FUSE HOLDER

The Sea-Dog Line 354-4451981 ATO/ATC Inline fuse holder offers a simple solution to protecting your boat. It contains two ATO Blade fuses for short circuit protection on twin engine installations, bow thruster installation of more than 30amp, one engine of more than 60Amp and external connections over 20AMP. This inline fuse holder is suitable for use with 12 or 24v systems.

The Sea-Dog Line fuse holders are designed to fit Sea-Dog Line style circuit breakers. The fuse holders are rated to fit Sea-Dog Line circuit breakers of either type (ATO/ATC) and are made of heat resistant material.

An inline fuse holder is designed for continuous power supply to loads up to 30Amps. It features two positive-connected 5A/250V stab-in blade fuses, 3m fused power supply cable, and translucent plastic cover with thermostat-contained bracketing screws clip. It has 12/24V DC voltage selectable, high quality plating contacts, customized wire lead polarity protection design, load current protections and overload protections.

Introducing a fuse holder made from the same space-age technology as our high current ignition leads. This is an inline fuse holder designed for maximum protection and safety for your boating system.

The Sea-Dog Line inline fuse holder is used in conjunction with Sea-Dog Line wire harnesses to incorporate safety features in your electrical system. It will accept glass or ceramic fuses, provides accurate overcurrent protection to eliminate damage due to short circuits or misapplication of wiring.

The Sea-Dog Line fuse holders are made in the USA with the highest quality materials. Each fuse holder has a maxi-fuse with dual blade terminals to ensure that your wires and fuses will not get burnt out. The line of fuse holders includes (1) 12 volt inline fuse holder and (1) 24 volt inline fuse holder.

The SEA-DOG Line Fuse Holder is a great solution for adding fuses to existing circuits. The holder has 2/4 female contacts and is made of durable polycarbonate material, with a stainless steel fuse/wire guide that can accommodate sizes from 4 AWG to 400 MCM.

The Sea-Dog Line fuse holder is made for use with 1/4'' self tapping screws (not included). The Coast Guard approved fuse holder should be used in systems with a maximum load of 30 Amps. This product should be wired off the battery negative terminal and not to the ignition switch.

These bulkhead mounted fuse holders are designed especially for use with the SEA-DOG Line® brand of high performance electronic controls.

The SEA-DOG Line Fuses are an ideal replacement for your failed fuse at a fraction of the cost.

SEA-DOG LINE manufactures a full range of superior concern with one prime objective: 100% client satisfaction. SEA-DOG Fuses are manufactured to ISO9001 & ISO14001 certification from Underwriters Laboratories Inc. To make certain product consistency, top quality and most secure manufacturing methodologies are implemented in each manufacturing process.