RHEEM 234439 -Ruud SP10758 3-TRY HOT SURFACE IGN MODULE

3-TRY HOT SURFACE IGN MODULE

This Ruud replacement product is a high quality genuine OEM part. It's efficiency has been tested and verified by the same engineers that design, test, and install the original equipment. Please be sure to purchase this 3-TRY HOT SURFACE IGN MODULE by RHEEM to maintain your system's warranty.

RHEEM 234439 -Ruud SP10758 3-TRY HOT SURFACE IGN MODULE

The Ruud SP10758 3-TRY HOT SURFACE IGN MODULE can be used in a variety of Ruud gas and oil furnaces. The 3-try module has two trip levels and is designed for use only with air handlers and packages featuring an RQA prefix. .

RHEEM® RUUD®'s "3-Try Hot Surface Ignition Module" provides the ultimate in home comfort - a superior level of control, safety and flexibility. With a new sleek design that's 70% smaller than standard models and a factory installed temperature setting switch, this replacement module is designed to fit most gas and oil heaters.

The Ruud 3-TRY hot surface ignition module is a replacement part for certain Ruud gas furnace models. If the pilot lights but the burner does not stay on, this is typically the cause. If your heater's flame does not turn off, chances are the limit control board may need to be replaced as well.

RHEEM 234439 Rheem Ruud R-GARD 1075 ENHANCED HOT SURFACE IGNITION MODULE REPLACEMENT

The M53/55-88 Manual Hot Surface Ignitors feature 3 interconnected "pop-out" tungsten fuses. Each ignitor in the module is rated for AC voltage of 48...4160 volts and a max. current of 50 mAdc. The NEMA 1 enclosures are powder coated to resist abrasion and corrosion.