SSTR MANUAL JACKPLATE 4"SETBACKThe SeaStar Solutions Manual Jack Plate (4" set-back) JP1040SS is designed to install over the existing factory jack plate on select Boats. The JP1040SS is shipped with...
SSTR MANUAL JACKPLATE 4"SETBACK
The SeaStar Solutions Manual Jack Plate (4" set-back) JP1040SS is designed to install over the existing factory jack plate on select Boats. The JP1040SS is shipped with slightly oversized cover plates to accommodate setback on your existing jack plate.
The SSTR Manual Jackplate is designed for mounting onto fiberglass hulls. It is equipped with(2) 1" wide rollers to ease movement from the boat to dock.
This manual jackplate features an onboard 4" setback, constructed of steel and is available in a high polished stainless steel or black oxide finish
Seastar Solutions 4" Manual Jackplate Model: JP1040SS - $149.99 Seastar Solutions' 4" Manual jackplate offers a strong balance of ease of use, good looks, and simplicity. Our 4" jackplates are made from one solid block of 6061 T-6 Aluminum. The large stainless steel adjusting nut is located on top of the jackplate and makes leveling your trailer a breeze! The large flange on the bottom of the Motor has been designed to allow you to bolt it down through your trailer floor or attach to another surface! To adjust simply loosen the stainless steel lock-
The JP1040SS is a manual jackplate that is made to meet the needs of an American Disabilities Act (ADA) compliant transfer system. The setback of 4" allows room for the wheelchair and caregiver on the opposite side of the door. This setback could not be obtained with a motorized jackplate. It also meant that a hall chair could be used in conjunction with this jackplate. This allowed the distance to be as short as possible for wheelchair access.
A manual jackplate for temporary jack installation or to give your Seastar jack plate a break. The jackplate is 4" long and the base uses a 1-1/4" x 4" U-bolt. The push button is included and is 3"to the top of the button. Depressing the button raises the jackplate up 2 1/2". Steel construction, durable gray finish
Manual jackplates usually allow you to elevate your boat up to 4" from its normal waterline when stowed. They work well with boats that have low transom obstructions, such as outdrives or other equipment. If you need to raise your boat higher than 4", then you should purchase a hydraulic jackplate instead.
HEWLETT PACKARD HARDWARE COMMERCIAL
This is a Hewlett Packard Hardware Commercial W2Q13-60103-OEM M329 Control Panel Assembly. This part is a replacement for the control panel assembly in HP hardware. This part is a replacement for the...
Take your meal outdoors with the Traditions 9-Piece Dining Set from Hanover Outdoor. This set includes six stationary dining chairs, two swivel rockers and a large 42 x 84 in. glass-top dining table...
SMOKE DETECTOR 5 YEAR LITHIUM
1/2 X 200 MOORING CHAIN SC