Johnson Controls 9120 STAT REV DUAL LOW VOL F

STAT REV DUAL LOW VOL F

Johnson Controls 9120 STAT REV DUAL LOW VOL F

Johnson Controls 9120 STAT REV DUAL LOW VOL F Thermostat, 900/230-2400, AC 115/230-Volt, 1.5A Phase Reversing, Dual Element

Johnson Controls 9120 Dual Low Voltage STAT REV DUAL LOW VOL F

Designed to ignite the devotion of fans, this controller is perfect for clubs, arenas, shopping malls and more. Its dual low-voltage outputs connect to two floor heating zones for lower energy consumption. STAT REV DUAL LOW VOL F has on/off switches on each output that can be set to on, heat or fan at any time. Its 16A rating is suitable for most systems with 250 V electrical supply...

The Johnson Controls 9120 STAT REV DUAL LOW VOL F utilizes two sensors in one unit to accurately measure temperature changes in refrigerator/freezers with dual doors. The sensor is located between the doors for accurate readings. This model can be used for both refrigerators and freezers. The dual low voltage solenoid valve will actuate to control the cooling cycle when the sensor detects a temperature differential at the dual heat exchanger (DHX) between the left and right door compartments. The power supply requirements are 24VDC to each solenoid, -10VDC at the magnetic reed switch to indicate

The Johnson Controls 9120 STAT REV DUAL LOW VOL F is a solid stat for the homeowner who wants to replace an existing thermostat and who does not require temperature memory. It allows two stages of heating and cooling, and it is equipped with an outdoor temperature input. The front-facing display has a built in clock, and you can program up to six scheduled programs per day or per week. The thermostat's reversible function will run the system in the opposite direction when energy savings call for it.

The Stat REV DUAL Low Voltage Fan is a single pole, 3 speed wall switch ceiling fan control. It has a built in light dimmer and long operating life. Installation is fast and easy with built in line/load termination.

The Johnson Controls 9120 8-inch dual low voltage stat. This stat has a high quality terminal block design with dual taps for current measuring capability and minimal wiring. The glossy finish allows for easy mounting to walls.

Designed to provide highly efficient motor operation, this controller incorporates a number of features, including separate low voltage control for heating and cooling. The system is configurable on a per-limb basis, which allows easy system expansion by using the same hardware to control multiple limbs. Our proprietary multi-start power conditioner provides extremely stable power to the system, even on multi-phase systems.

Designed for use in the air handling and heating system for medium temperature and low temperature applications. The adaptive controls allow all thermostats to communicate as one system, share information and operate as individual zones or as a whole.

Single-loop, direct-acting Type "D" thermostats with manual reset (except 9122 series)

A distributed control system replaces conventional single point-of-failure analog controllers and mechanical relays with a collection of small digital signal processors (SPDPs – called "brains"), which control the room-to-room and zone-to-zone processes. The brains are mounted on line cards, along with other electronics. Each card is mounted in a slot in the back panel, so it can be easily reconfigured as process or application changes.