TEMP CONTROL SPDT 0-100F 20' CAP.
TEMP CONTROL SPDT, 0-100F, 20' CAPACITY CONTROL SWITCH
The is a remote temperature controller with a 0-100°F setpoint range. It uses a 3-conductor shielded 24 AWG stranded copper cable and a 20' cable which minimizes the potential for interference which could cause unwanted operation or erratic performance. This type of temperature control can be used to open circuits that control heating and cooling equipment such as gas valves, gas heaters, humidifiers, dehumidifiers, and boilers.Control your air temperature with the Remote Digital Thermostat, part number 2901. It allows you to change setpoints from 20 feet up to 100 degrees, Fahrenheit. It includes a 3-wire copper terminal strip for easy installation and mounting. The remote thermostat can be used on any forced air heating system designed for an older Honeywell programmable thermostat model RTH2310B.
The remote bulb controller connects in place of a standard socket, allowing you to control any type of non-dimmable incandescent bulb from any location within 20 feet. The remote providing an adjustable output with precise 0.1 F increments (between 3-10F), allowing for better temperature control when using the hot water recirculation system.
This temperature controller (thermostat) is used to control a heating or cooling device. The device is controlled by a two wire circuit and may be connected to a sensor or switch approved for use with this unit. The sensing element must be located in the bulb compartment or within 1 inch of the bulb.
This is a Bulb/Pt100 temperature controller. It will control standard incandescent or 12 volt dc lamp loads from 3-10 AMPS and has 1/16 DIN male connectors. This is a high performance, long life unit...
HONEYWELL'S REMOTE BULB CONTROLLER MODEL 2901 IS A SPDT CONTROLLER FOR A BASIC 120VAC CIRCUIT, WITH ON / OFF CONTROL AND SETPOINT OF 90F. IT HAS AN ENCLOSURE OF HOUSING MATERIAL - STAINLESS STEEL WITH SCREW LID. THIS PRODUCT MEASURES 6" IN DIAMETER AND 1" IN DEPTH. COMES WITH 1/2" MPT TERMINALS.