Electronic Temperature Controller w
This electronic temperature controller is designed for use with models of portable or remote-cooled Dehumidifiers only. It can control two temperature settings, and two signal outputs, for maximum operating flexibility. The controller has a display with an off setting, a 24 hour countdown timer, and an auto-off feature which will shut the unit down if desired.
Our electronic temperature controller can be used in a variety of applications, including controlling the temperature of a hot tub, aquariums, or even home brewing. It is capable of controlling two heaters, two coolers, or one heater and one cooler. The digital display features an LED readout that can be set from 32F to 122F (to accommodate most hot tub requirements) and allows you to set your desired temperature in 1-degree increments; it will automatically adjust temperature as needed to maintain your selected temperature. It also comes with four pre-installed thermocouples for heating sensors, two pre-installed thermoc
Plug-in digital controller with two temperature inputs (RTD's or thermocouples) and two analog outputs that transmit temperature information to remote display or control panel.
The Honeywell 111290 temp controller helps you monitor and control temperatures in your marine, reef or pond water system. The controller receives input from two external sensors, one inside the case and one inside the tank. Using these two sensors the controller monitors and maintains a set desired temperature for your tank.
At a Glance:Puts you in control with two independent outputs, programmable up to 240 VAC at 16 A and 2 channels. Features include lockout knob, audible beeper, center OFF position, reset button. Includes 1 Type K thermocouple probe and 2 cables (6 ft) for direct device attachment, 4 ft (1.2 m) temperature sensor extension cable, 1 set mounting hardware and instructions. Easily adjust the outputs from the front panel or enter programming mode and access all options via the keypad.
This Honeywell ET9020B 10 Amp Electroni
Two independent programmable set points are controlled by this device. Each has an analog read out that can be zeroed for testing. Two independent channels of control are available. The controller has two sets of terminal blocks for plugging in relay type outputs. This controller is used to control heaters, heat lamps, etc., as well as fans and blowers. No additional input relays are necessary. This controller uses its own internal relay to provide the output power when the set point is reached. Keypad is located on top panel of controller for ease of operation during test or service work. The controllers have a reset feature and
Free Shipping
In stock
