Trane CNT5010 Defrost Control Defrost Control

Defrost Control

The defrost control monitors the temperature of indoor coils and automatically turns off the outdoor condenser fan when the air passes through the coils, preventing moisture from building up on the outdoor unit and keeping your system running efficiently

This device is used to control the defrost cycle of a forced air heating system

The two-stage timer cycle, activated by the defrost thermostat, automatically cycles on and off

This helps provide adequate time to remove any frost buildup within your refrigeration system

The Trane CNT5010 is a defrost control

The product’s model number is CNT5010 and it contains 1

The Trane CNT5010 Defrost Control is designed to regulate the defrost cycle in commercial refrigerators and freezers

Control board for the Trane CNT5010 series

Trouble free defrost control

You can also see its main characteristics, such as its strength and weaknesses, so that you can decide whether you continue reading about it or not

It will turn on for an initial stage of 16 minutes during a normal cycle and then will continue to run after the thermostat closes for 3 additional minutes at a reduced capacity

The unit features a simple slide adjustment, plus adjustable frost protection start and stop times

This Trane CNT5010 defrost control is designed to provide automatic defrost control for up to 10 indoor coil units

This is typically set at approximately 70F (21C)

It is designed for new construction applications where high efficiency and system reliability are critical

You will see what features it contains or even what kind of technologies it uses

The Trane CNT5010 defrost control uses a single, high capacity compressor to provide both heating and cooling

The Trane CNT5010 is a hardwired Defrost Control

Trane CNT5010 Defrost Control is a type of Trane product that has been manufactured by Trane Inc

Control requires the installer to set a temperature for the air entering each of the controlled ventilation zones

When this temperature is reached, the control indicates to the compressor that it can now begin its defrost cycle

The Trane CNT5010 defrost control is a defrost timer that operates in conjunction with other defrost components, such as the defrost thermostat, to deliver reliable operation

The Trane CNT5010 also offers a freeze protection feature that turns on the condenser fan if freezing conditions occur at night before all water in the system has evaporated, reducing the potential of water damage to your home

A mechanical device, this is not electrically powered

In the following table, you can find the different options that this Trane CNT5010 Defrost Control has

The maximum heat input of the unit is 22,000 BTU's

This product works with either 110 volt or 220 volt single phase power, so it will work in many different countries

0 lbs

It was first released on January 1, 2007

It has a high-efficiency design that helps to ensure consistent performance over time and minimizes energy use