Trane SEN0073 Flame Sensor Flame Sensor

Flame Sensor

This sensor is compatible with Trane air-cooled heat pumps

It can also be used for emergency heaters or furnaces that do not have a flame sensor but are wired for one

Flame Sensor by Trane is a flame sensor that is installed in the vent pipe of a gas furnace

The unit is designed to detect flames that may occur during combustion

It works with the following products: furnace, air conditioner, heat pump, packaged terminal air conditioner (PTAC), or a combination of these products

Installing a Trane® Flame Sensor can help you detect, control, and prevent combustion-related problems within your heating or cooling system

Flame sensors are located in the vent line because when a flame is detected, it closes the gas valve to prevent carbon monoxide buildup

Flame Sensor compatible with Trane heating and cooling systems to monitor flammable gas levels in the home

Connect this flame sensor to gas valve and circuit board of your heat pump, it can detect an increase in flame intensity or an ignition source as small as a match

The Gas Valve has two flames, one for pilot and one for main

This is a Flame Sensor by Trane

Flame Sensor is required for residential gas furnaces and water heaters when the unit is installed within 15' of an attached garage, laundry room or furnace room

The system will shut off the burners in a gas furnace if it detects a flame

Trane Flame Sensor is used to detect the presence and the movement of flame in gas-fired heating appliances

Sensor mounts to a Trane or other brand gas furnace to shut off pilot when flame is not present

This part is made up of flame sensing wire, which when put into the fire box in your home's heating unit, will help to control the temperature (heat) output and operation of your heating equipment when there is a fire in your home

It comes in a standard beige color, is 12 inches long and has a one-year limited warranty

The Trane SEN0073 Flame Sensor is used to turn the gas off if there is a flame in the fireplace, which may be caused by an inadequately installed venting system or improperly vented appliances such as a gas log

This flame detection system is designed to be used with Trane’s high-efficiency gas furnaces

A Flame Sensor is designed to indicate the presence of flame in the system as soon as it occurs and to shut down the HVAC system before any damage can occur

If flame is detected, the sensor will activate an audible alarm and/or communications device

Designed for use with the Trane gas furnace models ZBX and ZBXN, this flame sensor is a genuine OEM replacement part that you can quickly and easily install

When the flame goes out, a spring opens the gas valve again

The Flame Sensor is a device designed to sense flame in the presence of an open flame or glowing ember

This product can be used for residential and light commercial applications