Honeywell RM7895C1012 , Inc. Ec7895,A,C Rm7895 On-Off Primary Control With Prepurge

120V PRIMARY CTR 4 OR 10SEC PP

Honeywell On-Off Primary Control with Prepurge (4 or 10 second PP) 120V, ideal for fan coil applications in the heating, ventilation and air conditioning industry. Two-stage operation allows both constant cooling and constant fan during systems operation. Contactor operates as a control interrupter: ON when both contacts are closed, OFF when either contact is opened. Item has a delay to allow timed restarts of equipment in the event of short circuit.

RM7895C1012-ON/Off primary control (MMF) 4”, 10 second pre-purge, with normally closed auxiliary contact. The secondary shall be interlocked with the primary so that it is polarized when the secondary is OFF and de-polarized when the secondary is ON. A LF circuit breaker, designed with a 100% rated load limit shall be inserted in the branch circuit.

The RM7895C1002 is a 120V, single pole, 4-wire or 10 sec pre-purge control with continuous rating and is intended for use on gas ranges. The control allows you to select your desired combination of bake, broil, and self-cleaning temperatures.This control is used in gas range applications with up to two oven burners..

The RM7895C1012, Inc. Ec7895,A,C Rm7895 On-Off Primary Control With Prepurge is a 120-Volt primary control for quartz crystal electronic time delay or appliance control in suspended ceiling applications. The 5.5 amp current trip circuit breaker trips at 5.5 amps or higher and has a 10 second pre-purge feature, which closes the contacts for 10 seconds to purge the air from under the ceiling tile before tripping.

Honeywell Inc. ec7895,A,C, Primary Control with Prepurge. Honeywell ec7895 is a primary control that has the prepurge feature that is used during factory calibration before installation into the customer's system. This provides greater accuracy during calibration and assures proper functioning for the life of the control. Specifications: - 15-3/4 in H x 7-inch W x 4-1/4 in D. New usa made three wire 120v primary controls

The RM series On-Off Primary Control is used to control the on/off operation of heat producing equipment, such as boilers, furnaces and water heaters only. The knob style rheostat has a pre-purge feature to prevent power surges after startup. The black insulated case features a white dial scale with clear numbers that make it easy to read. It simply connects to existing 240V lines from a fuse box, between the fuse and starter.

This model of electric baseboard heater uses a primary control with a pre-purge to help ensure that heat is available at the touch of a finger. This feature takes water that was already heated by the previous cycle and pumps it into the baseboard coil, which rapidly raises the temperature of your room. Note: The pleat spacers are located on each end of the primary control assembly.