HONEYWELL 130367 130367 PLUG-IN CAD CELL PLUG-IN CAD CELL

Photoconductive Flame Sensor For Sequencing Oil Burner Systems | Shuts Down Protectorelay When Flame Goes Out | 60" Leads Includes Mounting Bracket | Use with #506610 Protectorelay

If it's time to replace your system's flame sensor, choose the Honeywell PLUG-IN CAD CELL for oil burner systems. The PLUG-IN CAD CELL is a photoconductive flame sensor that shuts down the protectorelay when flame turns off and allows it to reset when flame turns on. Its 60" lead with a mounting bracket makes the sensor easy to install and use in your home's oil burner system. This product is ENERGY STAR® qualified.

Set and go automatic ignition with plug-in cad cell. Good for applications up to 4 acfm (28 m3/h) of gas per burner. UL listed, CSA certified. Features: cad cell for use with specific Honeywell #506610 Protectorelay; Auto reset function allows flame to reignite after sensing a power disruption; All cad cells include 60" (152 cm) leads with mounting bracket and instructions; For use with natural gas only. Plug-in cad cell will not work on liquid propane installations; Not for use with models 4QMPK, 5VPMP or 5

The Hard-wire Flame Sensor is used with Honeywell's 506610 Protectorelay to prevent a fuel gas system shutdown due to the flame being out. When installed it will keep your gas system running uninterrupted when the flame goes out, protecting against carbon monoxide buildup.

The Honeywell 130367 plug-in quad cell is an oil burner control alternative for standard room thermostat models. Your model 130367 plug-in quad cell operates with #506610 protectorelay, #103352 wall thermostat. This Honeywell device has a photo-conductive cell that is used to sense the flame when an ignition pilot light or low voltage heat burners are used. Your new 130367 plug-in quad cell will be a direct replacement for your original one that came with your home heating system.

The Honeywell 130367 plug-in CAD cell is designed for use with Cadet CC1, CC2, CC3 and CGA1 oil burner systems. It protects gas control valves against discharge of flame in soot scrubbers, chamber transition burners, gas pilot flames and high altitude (above 4,000 feet) caused by changes in air pressure. The #506610 protectorelay must be used with this CAD cell.

The plug-in cad cell makes relighting a draft hood system efficient and possible. It works with the protectorelay functionality in a sequenced firing system to detect an unlit flame. The cad cell features a PL-5 contact that is compatible with 120/70V circuits.

Designed for use with modular heating systems, this plug-in flame sensor uses a photoconductive cell to monitor burner flame. When flame goes out, the sensor activates the sequence control to shut down pump and blower. Flame reinitiates in 30 seconds or less.