RHEEM 47-22860-0 Limit Switch - Auto Reset (HALC) Limit Switch - Auto Reset

Limit Switch - Auto Reset (HALC)

The Limit Switch - Auto Reset (HALC) is an automatically resetting thermostat for use with a gas or oil burner, furnace, space heater, appliance, or water heater. This switch functions as a replacement for a 250 °F Limit Switch and is intended for use on heating equipment requiring a listed 250 °F limit switch but also allowing the temperature to exceed this limit. For added safety and maximum energy efficiency features such as bulb out protection and automatic reset should be used in conjunction with this product.

The Limit Switch - Auto Reset (HALC) will replace the following Rheem part numbers: 47-22860-0, 47260-0.

RHEEM 47-22860-0 Limit Switch - Auto Reset (HALC) is used to stop a condensate pump from running when the water level gets too high.

Rheem DR1NZ2A180 Limit Switch - Auto Reset (HALC). 1-pole. 120-240 Volts. 5 amps. 50/60 Hertz. WHITE

The Limit Switch - Auto Reset is a 120/277VAC 12.5mm SPST, 20A, 1728/2412 ohm Limit Switch. The contact assembly is intermateable with any HALC type. This switch may be mounted in any position except upside down or vertically

Our HALC is an AC-operated, water-cooled, halogen-ignition valve. It contains an automatic reset for power failures and a limit switch with a latching coil.

This limit switch (HALC) is used in Rheem and certain American Standard Tankless Water Heaters. It has one terminal for the incoming power and two normally open contacts.