WHITE-RODGERS 65868 R Universal Silicon Nitride Hot Surface Ignition Control With Variable Timings

UNIVERSAL SILICON NITRIDE HOT SURFA

With this WHITE-RODGERS 65868 R Universal Silicon Nitride Hot Surface Ignition Control With Variable Timings, you will be guaranteed of getting maximum power output from your gas appliances. This is because it comes with solid two point mounting and easy installation which requires no electrical wiring to connect the control.

WHITE-RODGERS 65868 R Universal Silicon Nitride Hot Surface Ignition Control features a switch that handles up to 400 A instant at 240 VAC and 60 Hz. Includes a bakelite control knob, mounting hardware, and 3/4 in. pilot wire.

WHITE-RODGERS 65868 R Universal Silicon Nitride Hot Surface Ignition Control With Variable Timings

The WHITE-RODGERS 65868 R Universal Silicon Nitride Hot Surface Ignition Control has been designed as an exact replacement for existing stand alone ignition controls. The white-Rodgers control contains the following features: An adjustable lighting delay, interchangeable on/off/time switch, and an adjustable timing pot to accommodate a wide range of boiler manufacturers. This unit is similar to that used on the following boilers but is not compatible with all boiler brands and models.

Although the White-Rodgers 65868 R Universal Silicon Nitride Hot Surface Ignition Control offers a universal temperature range of as low as 000

The WHITE-RODGERS 65868 R universal silicon nitride hot surface ignition control with variable timings is designed for applications where a separate ignition coil and spark plug combination are used in conjunction with an existing power source, such as a standard 120-Volt heating system, to supply the energy needed to operate small appliances.

The 65868 R non-programmable universal single stage Silicon Nitride Hot Surface Ignition Control is designed for use with natural gas, propane, and direct electric spark applications. It is intended for applications with a burner input of up to 85kW at 80 PSIG. This ignition control features a 1/2" NPT inlet on both sides of the control body allowing easy piping configurations. The flame sense connection on one side of the control clears the use of splitters or multiple primary burners by a single design. Likewise, the control is available in right angle and vertical orientation for personalized fit requirements.