HOT SURFACE IGNITOR WITH 5-1/4" AMP
This White-Rodgers 102511 hot surface ignitor with 5-1/4" amp, an ignition module for a gas water heater.
WHITE-RODGERS® brand replacement hot surface ignitor with 5-1/4" Amp. This ignitor is for use with boiler, water heaters and the WHIRLPOOL® brand hot surface ignition system.
The WH-RODGERS White 102511 hot surface ignitor with 5-1/4" amp is designed for use in ballast or starter that operate at voltages between 120 and 240 volts. This ignitor has 230 mA breakers to prevent overloading. The white finish blends with any decor.
This document accompanies the Model 102511 Hot Surface Ignitor with 5-1/4" Amp . It should be read before purchasing, installing, or operating the part.
This hot surface ignitor is designed to be mounted on 220 VAC mains. It has an operating temperature range of 90° to 130°C (200° to 300°F) and has a current interrupting capacity of 80,000 Amps at 90/100VAC .
WHITE-RODGERS' hot surface ignitors are used with gas fired furnaces or boilers. They ignite the fuel at the burner and provide pilot ignition for gas heaters. Replacement hot surface ignitors are available for most models of furnaces and boilers.
A specialty device used for gas furnace startup-the pilot light ignites the gas, which then heats up the hot surface ignitor. White-Rodgers' 102511 is a hot surface ignitor that is designed for universal applications. It is an ideal accessory for expert furnace installation and repair work. This device is designed to fit any application.