TJERNLUND 4854 Impeller Wheel Kit for SS1, SS1C Sidewall Power Venters.

WHEEL FOR SS-1 5/8" BORE

This wheel kit is the complete solution to every squeak and rattle on your TJERNLUND, Model SS-1 Sidewall Power Vent. With its built-in dowel pin and flush tread mounting, this wheel kit makes installation a snap. This wheel kit features a standard 5/8" bore and should be ordered when combined with the 4844 Bearing.

This is a replacement wheel for the SS-1 brand of ventilators. It has an 8" diameter and a 1/2" bore with an 8 on 4 1/2 pitch size thread. This wheel was readily available in stainless steel but replacement wheels are no longer available for most sewer applications.

In addition to our line of complete and partial roof fans, we offer a full line of accessories. This Universal Winch is designed to fit our SS-1 Sidewall Power Vent but will also fit other brands of sidewall power vents with a 5/8 inch bore. This kit consists of retractable, stainless steel steering cable and powerful motorized imployer wheel , which are encased in a security cover that has been drilled out to allow for easy cleaning.

This replacement wheel is made with a solid stainless hub and 3/4" polyethylene spoke. It can be used to replace broken wheels of the sidewall power venting units (SS1 or SS1C) on a TJERNLUND Wood Furnace Wood Cookstove. It fits the 5/8" bore of most brands of stove pipe except for stovepipes that have reduced the diameter from 1-1/4" to something less than 5/8". Replace your

The TJERNLUND 4854 Impeller Wheel Kit for SS1, SS1C Sidewall Power Venters is the right replacement wheel for Tjernlund Power Vent parts. Each kit contains blue polyurethane wheels that can be attached to a Tjernlund model SS1 or SS1C by means of a stainless steel shaft. The 4854 Impeller Wheel fits into the vent wall so that it will spin freely, allowing hot air to circulate much more

The TJERNLUND 4854 Impeller Wheel Kit for SS1, SS1C Sidewall Power Venters is an excellent replacement for any situation where a damaged impeller wheel has been identified. The TJERNLUND 4854 Impeller Wheel Kit for SS1, SS1C Sidewall Power Venters also known as a fan blade, is meant to be replaced when the original has shown signs of damage or wear. If you are unhappy with the results of

The design of TJERNLUND Impeller Pivot Wheel prevents water from building up between the wheel and drum resulting with longer life. The pivot wheel bore is 1/2" larger making a better water seal.