ARGO 113 SAME AS AZV-245-75 FIVE ZONE RELAY

SAME AS AZV-245-75 FIVE ZONE RELAY

The ARGO 113 SAME AS AZV-245-75 FIVE ZONE RELAY provides all the best aspects with an exciting cheap price of 14.99$ which is a deal. It possesses countless elements including binding, FET, . and C. The ARGO 113 SAME AS AZV-245-75 FIVE ZONE RELAY weighs about 0.2 lbs.

The ARGO 113 SAME AS AZV-245-75 has four 110vac Or 18vac - 28vdc single pole relays, and one 110vac or 18-28vdc in series N/O (normally open) contact. Eight zone programming with 300 amp repeatable contact. There are two relays for each wireless receiver, and the receiver comes with an Infrared repeater to ensure reliable reception.

ARBEL AZV-245-75 five zone remote control relay. Protective cover and #14 AWG - #22 AWG wire connections for Zone #1 and #2. The other side has no connections for 3,4,5,6,7. This relay is constructed of 15/16" sq box tube with 0.074" thick cover plate. The bottom edge of each cover plate has a slot to screw in the factory connectors or to make factory installed panel wiring accessible without having to cut the cover pieced

The ARGO 113 can be used as a 74- or 102-input Five Zone Relay. The input wiring is the same for the two versions so only the printed circuit board needs to be changed. This model differs from the original ARGO 102 in that it has a buzzer output which sounds when all zones are deactivated and it has an All Clear input.

Five Zone Relays are designed for most common touch-sensor switchers. The relays, used in pairs, provide five zones to trigger the attached load and can be used with virtually any type of load controlled by a switch including lights, motors and heaters.

This device relays commands from your Crane Valve to your heating and cooling system. It can be configured as a normally open, normally closed, or latched, 5 zone device. This unit should be replaced if the contacts are pitted or the contacts do not "spring" apart when actuated by the wire for the crane valve.

The ARGO 113 is an expansion board for the arduino platform that allows you to interface with the Phoenix contact 5-Zone Relay, one of the most commonly used relay modules for home automation systems. This Expansion Board provides all the external connections including screw terminals and test points for easy access to all the signal and power connections.