JOHNSON CONTROLS F261KFH-V0 F261KFH-V0 SPDT LIQUID FLOW SWITCH LOW FLOW RA

SPDT LIQUID FLOW SWITCH LOW FLOW RA

The F261KFH-V0 SPDT LIQUID FLOW SWITCH LOW FLOW RA is designed for residential use. The switch is rated at 1/2 amps, 250 volts.

Two hole liquid flow switch for liquid temperature up to 52.8C (127F) in black"

Control your flow without sacrificing reliability The fluid flow switch (FSS) switches ON or OFF in response to the level of liquid inside. Built with PID-like features, the FSS provides an accurate measurement of position, while minimizing risk of failures due to misloading. The FSS requires no additional calibration or setup. It's easy to replace if needed and will not lock-up like traditional float switches.

The flow switch detects liquid flow as low as 250 1/min or 5 GPM. The stainless steel 316 marine grade, EPDM diaphragms have a 1.5 pressure differential. The cam disk shutoff draws down to provide a 1 shutoff and is guaranteed to remain fully open. The ball seats inside the valve are made from a high-grade stainless steel, brass and bronze for long lasting leak-free operation. The contact surfaces of all electrical terminals are tin plated copper alloy for corrosion resistance and high conductivity.

The Series F261KFH Flow Switches incorporate an electrically actuated, spherically balanced pressure-dependent float switch with tripping mechanism. The design is appropriate for marine and other low flow applications where accuracy and stability are of prime importance.

The F261KFH-V0 Flow Switch with Brass Stem is designed for use with Johnson Controls' F Series Liquid Level Controller, but it can be used with any standard liquid level controller that has 1/8" NPT threads. This flow switch is often used to monitor liquids at their source. The flow switch consists of the stem (brass) machine screw, brass nozzle contact, and nylon housing.

The F261KFH-V0 is a low flow rate valve, with 0.25 in H2O minimum flow and one inlet and two outlet ports.

The F Series Flow Switch Series is a general purpose, two-way flow switch that can be used in a wide variety of applications. Each model has a switch mechanism that provides positive switching action and long life performance , and the use of only high quality parts and materials provide reliable, long service life...

The F261KFH series is designed for feedback type use in direct-acting or proportional control applications where panel space is limited. The F261KFH controller has a built-in override switch to stop the control when an over-travel condition occurs. The low flow rate model is used in systems with low flow rates, typically a system with a relief valve in a steam or hot water pipe.

Ideal for applications where the flow is relatively constant and throttling valve action is not needed.

The F261KFH-V0 is a switch, actuator turn on. When the input voltage is applied to the push buttons, the push buttons push to close contact.