Honeywell MS4609F1010 , Inc. 230vFireSmoke80#2posSR Act

230vFireSmoke80#2posSR Act

Find out what the 80#2posSR Act means for your business. The 80#2posSR Act governs the amount of halon gas that can be used in a fire suppression system sold in the USA. In order to comply with the new ruling, you must conduct testing on your fire systems at least once a year. So, make sure you're using a fire protection company that not only sells equipment, but also performs testing. Count on Fire Inc to provide all the necessary testing and maintenance services for your halon and CO 2 fire suppression systems throughout the year (including scheduled inspections) - so you don't have

These units combine both a direct and reverse acting controller, a low level detector, and a standby80#2PositiveAirFlowSR actuating device in one unit. The MS4609 fire control units are built to IEC standard 618 for detectors and controllers. The MS4609 series fire control units have an integral deadman style actuator, with an 80mm stroke, and are suitable for use with 80 mm ducted heating systems.

The MS4609F1010 from Honeywell is an intrinsically safe fire/smoke detector. As such, it is not needed to be intrinsically safe according to ISO standard 14116. The detection technology of the SMOKE80 #2 detector is based on electrical resistance sensing using a patented ceramic element that results in minimal false alarms and the detector responds with little delay upon fault condition detection.

This unit is designed as a simple Optical Smoke Detector (OSD) module for use with conventional fire systems. The OSD acts as the optical path between the Fibre-Optic cable and conventional detection tube.

Honeywell MS Series fire alarm systems are easy to install and maintain. Choose from Honeywell's low, medium and high level of protection MS Sprinkler Systems. Our fire alarm control panels provide a variety of features including:

The MS4609 is a new control panel for System Sensor product line. The MS4609F1010 is a front access Control Unit designed to address the need for an access point on all front access panels in a fire alarm system. The MS4609 supports up to 80 devices in Loop 1 while still maintaining its full set of primary zone capability.

The MS4609 is a control unit designed to operate fire protection alarm signaling devices and controls for single station fire alarm systems. It is suitable for use with most battery-less manual pull stations and annunciators. This control unit is also designed to be used with non-sensor-based detection devices such as smoke detectors.