Honeywell M847D-ZONE 24v S/R Open AirZoningDampAct
TRUEZONE REPLACEMENT ACTUATOR - ZON The Universal Zone Actuator from Honeywell is used in conjunction with the 875 series of open air zoning dampers and the 831 damper actuator designed for most...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountDCA 24v 2-POS S/R 88#IN W/2aux
The DCA 24v 2-POS S/R 88#IN W/2aux temperature controller from Honeywell is suitable for use with thermostats up to 32.5?(830mm) in length and provides 10ft of cable length. This unit is designed with a low voltage disconnect switch and an auto restart facility in case of electrical power failure. The PTC terminal block has a current rating of 5A at 250VAC, while the S terminal block produces a current rating of 2A at 250VAC.
The Honeywell MS8110A1206 DCA 24v 2-POS S/R 88#IN W/2aux DCA 24v 2-POS S/R 88#IN W/2aux is a DC Air Circuit Breaker that complies with American National Standards. This unit has a 3 pole, 2 position design configured for air, and has a trip current of 30 Amps and a interrupting rating of 88 Amps. It's 88.#IN, anti-corrosion type and metal contact trip mechanism requires as much 40VDC power. The trip rate is 10KA .....
The Honeywell MS8110A1206 DCA 24v 2-POS S/R 88#IN W/2aux is a motion detector that safeguards against theft, damage or false alarms. It offers vibration- and tilt-based detection, a sounder, and has an adjustable detection area.
The MS8110A1206 DCA 24v 2-POS S/R 88#IN W/2aux Honeywell thermostats for heating and cooling control of modulating gas, oil, and electric furnaces, as well as standalone air conditioners. The model is UL listed and CSA certified.
The MS8110A is a 24 Volt DC Auxiliary Contact Assembly with two normally closed aux contacts featuring 88 pound wire and screw terminal assemblies.
Cabinet cutouts – S/R (Direct Spill/Recovery) versions of the 88/88C and 88T refrigerators include an additional dimension for front cutouts. This added depth allows for easier retrofit in racks where the equipment back extends beyond the height of the standard cabinet.
The 80 Series 2 Auxiliary Contact DC Power Relay connects to a DC power source to control an auxiliary load. It can be used as a switch or as an infinite on/off power supply. The control signal is provided by one of the auxiliary contacts and the load is powered by 24 VAC. It can be ordered with a 5 VDC feedback circuit so it may be used to control a 5 VDC load or for switching of voltages other than 24 VAC.