Honeywell R24BA3002 HtSeq2sw On30-90sec Off 1-30 HtSeq2sw On30-90sec Off 1-30

Heat Sequencer with two switches

This Heat Sequencer is used in environments where power fluctuates between OFF, ON or ON for a short period of time. The Device has two switches to control the output (ON or OFF), and it consists of four relays (two for High Limit, two for Low Limit) that are connected to each other by diodes. Each relay has its own output contact (NO and NC).

The Honeywell R24BA3002 Heat Sequencer has two switches which enable you to program up to three on/off cycles at different times. It also has a manual override switch for the second Heat Segment should you need it. It is used in conjunction with other Honeywell On/Off heaters as part of a timer controlled thermostat temperature control system.

This heat sequencer has two switches for activation of the control loads. One switch controls the first stage and the other switch controls the second stage. This heat sequencer is oil filled with a fluid temperature range of -65 F to 300 F (-54 C to 149 C). An epoxy sealed housing, complete with built-in terminals, prevents electrical leakage and protects against environmental contamination, ensuring continuous reliable operation.

This 2-switch Honeywell Heat Seq 2 Stage safety device sequentially controls two heating devices to maintain a constant temperature within a specific range. The sequence is: On 30 sec, Off 1 min, On 30 sec, Off 1 min.

This digital heat sequencer allows for more precise control of your HVAC system. There are two relays with a separate terminal, each used to turn on and off electric heaters or pumps. The unit can be configured to operate in one or two-stage sequence. The output is rated for 24 Vac, 100 watts per circuit. This means the unit is capable of controlling up to two circuits or 1000 watts of capacity per stage and can handle 240 VAC equipment.

The Honeywell R24BA3002 heat sequencer is an easy to install and programmable thermostat for use with a heating system. It has two independent programs that allows you to run two different heating cycles at the same time. The sequencer has a visual display that shows the status of each cycle and the current temperature, and has a range from 30°F to 90°F.

The RTHSeq2 Software lets the user select from any of the 21 heating event conditions defined by the HtSeq2, and then display and edit them with a graphic-oriented Windows-based program.