Johnson Controls EP-8000-2 Electro-Pneumatic Transducer, High Volume Relay, 0.25 to 9.5 Vdc Input Range

E-P TRANSDUCER 0-10V HI VOLUME

The EP-8000-2 E-P Transducer converts a normally open or normally closed signal to a 0-10V DC output. This high volume relay is an essential component for electro-pneumatic control systems that utilize proportional pressure, flow, and/or level sensing elements. (when used with the HVL 0-10V High Volume, this transducer will route fluid from 0-100 psi).

EP-8000-2 0-10V HI VOL EP TRANSDUCER, Electro-pneumatic transducer, 350 ohms, 50,000 cycles (50 VDC), rated pressure 50 psi, volume range 500 to 4500 scfm (0.25 Vdc), 2000 to 9000 scfm (0.75 Vdc), 5000 to 11000 scfm (1.25 Vdc)

The E-P Transducer is a high-volume electro-pneumatic relay. The relay can be supplied with 0-10 VDC at 1000 to 3000 psi. It can cycle up to 10 gallons of compressed air per minute and provides a voltage output proportional to the air flow (less than 5 percent offset) when pro cessed with most systems

The EP8000-2 Transducer is a high volume, general purpose pneumatic transducer. It can be used to measure flow at low pressure differential for starters and regulators or to actuate valves in the 0-10 Vdc input range. Its rugged design provides long life span and excellent performance.

EP-8000-2 is a electro-pneumatic transducer, high volume relay. The pneumatic transducer provides voltage output on the ENC (electronic) input.

The EP-8000-2 is an electro-pneumatic transducer with a high volume relay used in a variety of air and gas applications. It has a 0.25 to 9.5 Vdc input range, and a flexible mounting capability that allows for direct mounting onto the end of a tube or manifold, or remote mounting with an external sensor. The EP-8000-2 has an optional choice of attached cable lengths, allowing it to easily be integrated into many types of installations.

The EP-8000 Series (EP70002EP70005) electro-pneumatic transducers provide precise control of volume for heating/cooling systems and are designed for use in high volume applications such as electronic centralized building control systems. These transducers have an output frequency of 0.25 to 9.5 Vdc and may be configured with either a normally closed or normally open pneumatic relay contact. The EP-8000 series includes several sophisticated features including the following: