Johnson Controls T-5210-1007 8 ft Copper Averaging Element with 1 ft Copper Capillary , 50 to 150°F

"TRANS. 50/150

The T-5210 thermostatic control provides accurate, responsive temperature control from 50 to 150°F. The T-5210 contactor is ideal for heating applications that require separate on/off switching and temperature control. An electronic transformer controls the radiator output, which is continuously monitored by a bimetal thermostat. The system switches on as needed and remains on until the setting is reached.

Johnson Controls T-5210-1007 8 ft Copper Averaging Element with 1 ft Copper Capillary , 50 to 150°F

Johnson controls Transformer T-5210-1007 8 ft Copper, 150 Parallel taps

The T-5210-1007 series elements are used in a variety of industrial and commercial end uses including heating high temperature corrosive, oxidizing or aromatic liquids from 50°F to 150°F (10°C to 65°C).

This averaging element is intended for use as a substitute for an element of the same length and temp rating as shown on page 374 of Weco's catalog. When replacing such an element into a same size furnace, no change in the furnace wiring scheme will be necessary. The element shown above has resistance wire wound around protective rods which are press fit into insulated wells molded into the bottom surface of the element. Power wires enter and leave this averaging element through bushings which plug into holes at each end and seal against air and moisture with #2 or #3 heatshrink tubing. Chart-Pak"

The T-5210-1007 Copper Thermowell is a 1 ft long capillary tube that provides a connection from the process to an instrument. The thermowell is inserted into a jacket or into a reactor vessel and then connects to an instrument through a weld nut or integral connector. #33380755000"

The "T" Series Primary Copper Relay is used for on/off control or limit protection of low pressure steam or liquids. Designed for on/off control, the "T" relay may also be used in many applications which require limit protection of low pressure steam or liquids.

Achieve the best thermal efficiency at any setting with Johnson Controls (JCI) T-5210-1007 8 ft copper averaging element heater. This commercial-grade water heater has a larger element that aids in heating more rapid and ensuring even temperature distribution. It is suitable for temperatures of approximately 50 to 150 degrees Fahrenheit. The 8 ft copper averaging element is simple to install, making it ideal for residential or commercial applications alike.

The Johnson Controls/Unitary Products 84-00271-00 is a continuous flow averaging surface dry-duct thermowell for use with the TGP and TGL Series of square tubular heat exchangers. The thermowell has a 8-inch outside diameter and a 100-degree bend radius."

Averaging element designed for use in steam tracing systems where a 2-wire 4-probe scheme is employed to provide continuous monitoring of steam usage. The element consists of a 1 ft capillary and electrode assembly shielded by a 3/4 in solid copper casing.

The T5210-1007 type 10 (heavy wall) pipe element is designed for constant temperature control of ethylene glycol (standard base) ethylene glycol/water mixtures in 2 drum 2-roll mills using air or nitrogen gas.

Stealth Series™ Direct-Fired Two-Stage Heat Pump/AC Packages with 14 SEER