Lennox 79L60 FLAME SENSOR LEAD FLAME SENSOR LEAD 79L60

FLAME SENSOR LEAD

The Flame Sensor Lead converts output of the flame sensor assembly to a current suitable for connection to HSI display panel.

The Flame Sensor Lead from Lennox Air Conditioning is a 52" long lead used with the T-STAT 3 Control Board for natural gas furnaces.

The Flame Sensor Lead (79L60) is used to power the control board with 120/240-Volt AC electric. The lead measures 10 ft. in length and is supplied with a standard "L" connector.

The Lennox 79L60 Flame Sensor Lead is a two wire flame sensor that fits the following units: 1CPM-89C, QCC11-24, CMMH-22B.

The flame sensor lead is meant to replace the original lead wire between the flame sensor and the electrical box. The lead should be replaced if it has been cut or burned through, or if damaged in any way. This part does not require any tools to install, as it slips directly into place on top of your existing pipe and wires.

This flame sensor lead goes between the flame sensor and the electronic control board. This part is not used on all Lennox units, but it's manufactured as a spare just in case you need one.

This lead is used to connect a Flame Sensor to the gas valve of a furnace. This part can be installed on 79L60 furnaces.