Lennox Y5352 Flame Sensor Kit

Flame Sensor Kit

Flame Sensor Kits that include the new Op60F thermostat, Flame Rod, and a 60' wire harness. All Flame Sensors are designed to monitor the heat produced by the burner flame mechanisms

Trust Lennox to deliver superior HVAC equipment and supply quality support that's simple. The Thermostat is Cl35FF Flame-Free with 5CFM Filter Static Pressure.

The Flammable Gas Indicator (FG) and Flame Sensor OP60F are designed to protect stored or transportable fuel from accidental over-pressurization, leakage, fire or explosion. The OP60F detects an open flame within 2 inches of the sensing face. Both devices monitor this hazardous condition by utilizing a visual and audible alarm device in case of accidental over-pressurization, leakage, fire or explosion.

Lennox flame sensor kit for gas/ coal burning furnaces and boilers. Includes a 60-amp thermistor with a furnace mounting bracket, 2 nylon wiring nuts, 3/4 in. x 5 ft. flex conduit, 1 spst rheostat, instructions and hardware .

Keep your home warm and cozy this winter season with the flame sensor kit from Lennox. This Flame Sensor Kit helps prevent unwanted false alarms caused by kitchen, fireplace or candle use. The flame sensor kit without a thermostat may be added to any Nest Learning Thermostat on the market today to boost its functionality. The flame sensor kit comes with all necessary parts and instructions that will help you install it quickly.

This flame sensor kit works with the Lennox Residential Broiler Model Y5352.

Protect your family from dangerous gas leaks and get the accurate gas readings you need with this genuine Lennox flame sensor kit. This flame sensor with an output of 6.5 ohms measures flame detection for natural and propane gas, and includes a built-in optical pyroelectric infrared emitter/detector sensor that works under all weather conditions. Installation is easy--just replace your old one with this direct replacement!

Attractive and affordable, the Y5352 Flame Sensor kit is compatible with several Lennox systems. This flame sensor kit protects your system from flame failure due to obstructions in the burner flame such as soot or dust. It is also designed to protect you from excess carbon monoxide by alerting you of any flue obstruction. The flame sensor kit can be easily installed and has a working temperature of -40 to 150-degrees F.

This thermistor kit is designed to provide accurate and reliable flame sensing up to 35,000 BTUs. The flame sensor kit monitors the pilot flame when a standing pilot is used or a natural gas line with no pilot.

The Y5352 Flame Sensor Kit is designed to detect flame failure in a Lennox® brand furnace.

The Lennox Flame Sensor Kit is used to monitor and/or detect a flame as well as a location of where the flame is located within the ductwork. The Flame Sensor Kit includes the Flame Sensor and Wiring--ATTACHMENTS AND ACCESSORIES MAY BE REQUIRED.

Turns on heating and air conditioning units during pilot light operation and when the room temperature falls below 55 °F (12.8 °C)-or above 85 °F (29.4 °C).