JOHNSON CONTROLS P10BC-7C P10BC-7C LOW PRESSURE CONTROL 3/20PSI SPDT

LOW PRESSURE CONTROL 3/20PSI SPDT

LOW PRESSURE CONTROL 3/20PSI SPDT, WELLS P10BC-7C (P10BC7C) | SENSORS & SWITCHES | JOHNSON CONTROLS

JOHNSON CONTROLS P10BC-7C P10BC-7C LOW PRESSURE CONTROL 3/20PSI SPDT. LH & RH terminal block format; snap-in style; 1/4" MPT; metal enclosure; spade terminals; brass material.

The P10BC-7c Low Pressure Control is a 3/20 PSI SPDT (SPeed Double Throw) low pressure control designed for use with evaporative and dryer cabinets in the HVAC industry. This control features a steel enclosure, two M3 mounting holes and a center off style switch.

Low Pressure Relief Valve. 3/20PSI SPDT. 15-72 wire wound pressure switches. These series of pressure switches are designed for use in a variety of equipment and systems used to control, measure and regulate pressures in gases, vapors and liquids.

Johnson Controls (P10BC-7C) P10BC-7C Low Pressure Control, 3/20 psi SPDT, Push to Connect male luer x male pipe. The pressure control must not be used as a substitute for the disconnecting means required by the ASME and local codes and must not exceed the set point of 60 PSI (gage). Actual flow should never exceed 40 GPM (gpm) and minimum should not be less than 2 GPM (gpm). If there is no relief valve attached to the system the minimum should be no less than 1.5 GPM (gpm

The Johnson Controls P10BC-7C is a new, aftermarket, Low Pressure Control designed for use with packaged units for CP units. It controls the low pressure blower on packaged units at pressures between 3 to 20 PSI.

Plug-In Control, SPDT, Pressure Range: 1.0 to 20.0 PSI, 3/8 In. Hose Barb Inlet and Outlet, Nitrile Butadiene Rubber Diaphragm

The Low Pressure Control is designed for the HVACR installer's application of controlling water temperature during the heating or cooling of domestic hot water, or for mixing two different sources of chilled water. The control may be installed by field wiring (screw terminals) or by utilizing the optional face plate (snap-in connector). The Low Pressure Control has a 5/8 in stem type actuator with residual pressure spring.

Sealed Electric Low Pressure Control P10BC-7C

The P10BC-7C control is used with Johnson Controls'

A control valve modifies the flow of a fluid, such as water or steam. In a steam boiler or a steam turbine, it is the movement of steam that turns the blades of a turbine or a pump. In an air conditioner, it is air moving out—or in—the coils. In a gas furnace, it is gas fumes going through a flue liner and up the chimney. A control valve regulates the amount of air going through a shock absorber or a power steering line.